2007 Chevy Impala Starter Replace

2007 Chevy Impala Starter Replace

Two 15mm bolts holding the starter.

85
Like
Save


Comments

keith watson says:

I having a hard time manuevering my out on my 2006 impala. What else do I
have to take off. 

Ethaniel Lopez says:

i didnt how to reconnect the wires to the starter

hp11208 says:

did you figure out it.

hp11208 says:

It was bad,no start.

hp11208 says:

The red wire is the b+ that sends 12v fromthe battery to the starter.It
should connected to the bigger screw,and the black to the other small one
thats ground.

hp11208 says:

Alternator or battery drain.

merril72 says:

Thanks for the help you saved me money

hp11208 says:

Sounds like you have a weak battery.

Carl Garner says:

thanks for the tips now i can change the starter myself, i have a 06
Impala. do u know where the CamShaft Position sensor is located. that would
be a BIG BIG HELP.

Jay Fountains says:

You should make more vids if you do any more work on the impala that would
be dope… Keep it up man

hp11208 says:

Ok that one needs to be connected to the closes screw.Send a pic of it to
me if u can.

hp11208 says:

Thank you for watching,glad to help.

hp11208 says:

Dont really deal with alarm system.

prospect1496 says:

I have a 2006 impala with front wheel drive. The previous owner had an
alarm system with a hill function on the car which I wish to remove. There
are two wires running to the unit. Black and Red. I think they’re connected
to the starter but don’t know for sure. I was told the device is used as a
bypass when starting the car. How can remove the device while ensuring the
car starts?

kahikamsdad says:

There is a red wire and a black wire im not sure which one goes where?

santos garza says:

hey i got 2008 impala ls 3.5 liters and my baterry drain so fast i got a
new one but still the same u think is the alternator or starter? or what
can u help me

hp11208 says:

Thanks for your comment.

Matt Boblit says:

Thanks for the video, made it a lot easier to find the starter

kahikamsdad says:

Can you help me? How.does the wires go on starter which one goes where

hp11208 says:

I try to make as much I can get to fix,thanks for your comment.

Carl Garner says:

thanks again

kahikamsdad says:

I just checked and both screws are same size. I have one screw that has a
wired connector running to it from inside starter

jnj2909 says:

why did change the starter. i have a 2006 impala it sometimes cranks
slowing. Like when i turn the key it starts off like its struggling or
something it only happens sometimes.

hp11208 says:

@cgarner1198 I think its next to the power steering pump which you will
need to remove also.Good luck,thanks for watching.

Roland Drummond says:

Which engine is that? 3.5? 3.9? Thanks.

Write a comment