How to install a hotwire kit on a thirdgen, this car is a pontiac TTA . This can also be applied to a Buick Grand national.
check out my channel for more videos:
How to fix a 4L80e transmission where the connector pushes into the case:
https://youtu.be/xHHUfsP-r5Y
How to change a tire pressure sensor (TPMS) yourself:
https://www.youtube.com/watch?v=PDpDm…
Dakota digital dash Install (1982-1992 Camaro)
https://youtu.be/-QJYpXe1jGc
How to install a 4L60E transmission:
https://youtu.be/Fi5FjmAUqfw
How to Wire A Switched fuse block:
https://youtu.be/lUTfcUeRVkI
Best LS SWAP guide on youtube:
https://www.youtube.com/watch?v=68GWzhXKVPw&t=10329s&ab_channel=klowny1969
Vintage air serpentine setup:
https://www.youtube.com/watch?v=ByVdD…
How to Upgrade your fuel pump:
https://www.youtube.com/watch?v=8-7sB…
How to install an electric vacuum pump:
https://www.youtube.com/watch?v=i1n3b…
How to build a camaro from top to bottom:
https://www.youtube.com/watch?v=5twT_…
400 Cubic inch small block Dyno testing:
https://www.youtube.com/watch?v=eavm4…
How to Clock an Alternator:
https://www.youtube.com/watch?v=_I24m…
How to Replace a u-joint:
https://www.youtube.com/watch?v=QQsXs…
How To install a trans pan drain bolt:
https://www.youtube.com/watch?v=zXFCB…
How to install subframe connectors:
https://www.youtube.com/watch?v=9n1Yc…
How to do a quick wheel alignment (toe in toe out):
https://www.youtube.com/watch?v=Ycdoo…
klowny1969 – best car mechanic on youtube
Only clown mechanic in the world ! Uses for an air hammer
This video can be applied to chevy, ford, mustang , impala , camaro , corvette, truck , toyota, lexus , honda , nissan. etc.. volvo cadillac gmc astrovan truck blazer silverado turbocoupe thunderbird clown clowny69 klowny69 GMC Savana 2500 Siera 1500 Sonoma isuzu hombre GMC what a bad sway bar bushing sounds like and how to replace Ronaldo youtube channel 1991 1992 1982 1983
How much you want for that green 3rd gen RS?
Can you download a drifting video?? and thanksā¤
Wrap a piece of black tape around that red ground wire so people know it was purposely used for ground.
damn, that's a lot of work!
Great install Klowny. That's one sweet motor .
Those Stamped bars under there (tossed mine, made for sloppy rear)………… Nice vid, never knew of voltage drop down back on pump. 25% is a lot. Fair bit of work involved.
Not a very hard upgrade. Looks good!