I changed the lower ball joints on my 2000 Cadillac Escalade. I used a ball joint press and I had the help of a hammer. I replaced the lower ball joint will the lower control arm was still attached to the vehicle. Repair your ride and eliminate clunking noise on your vehicle. 94-99 Chevy trucks and GMC trucks
Don’t forget to torque the hub nut to 165ft lbs.
Ball Joints http://amzn.to/2BgGZ2R
Ball Joint Press http://amzn.to/2DWyhK2
Throw seafoam on it to get joint out
Great vid I have this same 2000 escalade gave me great direction. For all these people critisizing I just have to say he got the job done quit hating, if you know what your doing why u watching the vid lol!
24:23 Truth!!
You can shorten video to last 5min.
Good video. The only addition I would add of note, the axle nut needs to be torqued on with a torque wrench; should be 165ft lbs for the 00 Escalade.
Two things you got wrong.
1) You did not need to remove the hub (three bolts holding it on). The whole steering knuckle with the hub will come off in one piece.
2) You're using the press wrong. The sleeve is supposed to go on the top side. You don't need a sleeve on the bottom. This is why you couldn't fit it on top.
good job bra know this is a old vid
nice video buddy! thanks
hey man I had one question for you about the the cadillac sts. On my cadillac sts it shows a "Service air bag" sign and I don't know what it really means I was wondering if you know anything about that +oxmanagain
good video,thanks.