Car Fix DIY Videos

**Tools and Materials Needed**

* New oil filter (correct for your vehicle)
* Oil filter wrench
* Drain pan
* Socket wrench set
* Clean rags or paper towels
* New engine oil (check owner’s manual for type and quantity)
* Funnel
* Jack and jack stands or ramps (if needed)

**Preparation**
Make sure the engine is cool. Park the vehicle on a level surface and engage the parking brake. Raise the car with a jack and secure it with jack stands if necessary.

**Drain the Old Oil**
Place a drain pan under the oil drain plug. Use a socket wrench to remove the plug and let the old oil drain completely. Once drained, wipe the plug and reinstall it securely.

**Locate and Remove the Oil Filter**
Locate the oil filter — usually a round canister that’s either on the side or bottom of the engine. Use an oil filter wrench to loosen and remove it. Be careful; some oil may still be inside. Place it in the drain pan.

**Install the New Filter**
Before installing the new filter, apply a small amount of new oil to the rubber gasket on the filter. This helps it seal properly and prevents sticking during future changes. Screw the new filter on by hand until it’s snug, then tighten slightly more (usually ¾ turn).

**Refill with New Oil**
Open the oil cap on top of the engine and insert a funnel. Pour in the new oil according to your owner’s manual specifications. Replace the oil cap.

**Check for Leaks and Oil Level**
Start the engine and let it run for a minute. Check under the vehicle for leaks. Turn off the engine and wait a few minutes, then use the dipstick to check the oil level. Add more oil if necessary.

**Dispose of Used Oil and Filter**
Take the old oil and filter to an auto parts store or recycling center that accepts used oil. Never pour oil down the drain.

#automobile #mechanic #car #honda #bmw #cars #mercedes #motor
#OilChange
#CarMaintenance
#DIYCarRepair
#OilFilterReplacement
#AutoCare
#CarDIY
#EngineMaintenance
#VehicleMaintenance
#CarRepairTips
#MechanicLife