In this video I show you how to install a K&N® Cold Air Intake kit on a BMW 3 Series E46 Chassis, (M54 Engine). Car: 2005 BMW 330xi Sedan This video immediat…
In this video I show you how to install a K&N® Cold Air Intake kit on a BMW 3 Series E46 Chassis, (M54 Engine). Car: 2005 BMW 330xi Sedan This video immediat…
You must be logged in to post a comment.
European cars with european mods always requires a fair bit of fiddling and
violence to get things to fit for some reason
Did you notice and hp gains or any sound change. Perry wolf.
No problem Adam, through our collective efforts we’ll make DAMN sure nobody
EVER removes that clip! ;)
Will this fix work on a 323i ?
Where can I buy this K&N cold air intake to install it in a 2001 BMW 325i
and also will this intake fit on this car? I’m kinda new to all this
mechanic stuff.
9:27m You should spray the filter with the K&N Dust Collection Spray. (Im
sure you either did it or it came pre oiled. Either way, for everyone else,
this is a VERY important part)
Thanks man
Thanks for answering my question:) keep making good videos!
i tried putting one of those things on my e46 but the check engine light
went on and then it started missing. everything was tightend and installed
properly, and it still went on, any suggestions
“Мастер” рукожопый … Ничего не протёр, всё загнул,продавил… Пиздец
просто!!!
Great Video. I had a cold air intake fitted on my BM, they do look ugly. I
found a really well designed bracket on ebay that lines your performance
air filter up exactly with your snorkel cold air feed, looks good too.
http://www.ebay.co.uk/itm/141162161200?ssPageName=STRK:MESELX:IT&_trksid=p3984.m1555.l2649
And what is the difference from the 57I-1000 model. I get the legal issue
but does the model on the link have something extra than the 57I-1000? I
live in az will by the way
do you NEED the heat shield? or can you just install the filter alone
Will this model got on a 2000 323ci?
You’re welcome man.
Very helpful video thanks bro
kinda winded there buddy? great video. very helpful thanks.
thanks for the video… any improvement on the hp or torque?
That metal clip you can just push down to pull the plug off the maf just a
FYI
Well there you go, less likely to lose the clip that way. Thanks for the
input!
Thanks! Hope it helped.
No problem, hope it helped. 🙂
Well I feel like a dumbass I see a couple others have mentioned it sorry
great job mate
Ha ha. All you have to do was press down on the clip and pull the wire off
the sensor… You just broken it by prying it off
Here you go: /watch?v=hieGVRl-1FU
Great video, thank you.