Is there a reason why my shock mount has play after following the instructions in the video? Should I try to tighten the top bolt again when the car is sitting on the ground?
There was play in the top part of the coilover after tightening it with an impact and after installing it going over bumps there is a clunk noise anyone know what the problem is?
My car came with different coilovers, what if the rear doesnt have the little washer thingy that prevents the coilovers to go all the way up into the car
){kind=link}
Is there a reason why my shock mount has play after following the instructions in the video? Should I try to tighten the top bolt again when the car is sitting on the ground?
There was play in the top part of the coilover after tightening it with an impact and after installing it going over bumps there is a clunk noise anyone know what the problem is?
On the fronts when you impact the top bolt on is the top hat supposed to wiggle like in the video or be firm
How tight to I make the top nut
Does this fit 07 328xi?
Any recommendations for spring weight preset
Can I add camper plates instead of the OEM mounts ?
i am having trouble on the front suspension when i try and get the middle nut to go all the way down, the strut in the middle just spins
Does it have to be oem top mount?
What’s the need to remove the fender liner?
I bought a car with ST coilovers on it. Car is too low for me, so I have to figure out how to raise the back.
Thanks for the clear and concise video!
Does the kit for the 07 Bmw 335i e92 fit the e93?
having issues with installing the top nut. dont see how you can get the wrench on there if the mount is covering the nut
is a strut carrier gasket recommended?
Do the rear shocks have adjustable height?
My car came with different coilovers, what if the rear doesnt have the little washer thingy that prevents the coilovers to go all the way up into the car
What if u don’t have an air compressor
Man , thank god I found this video.
I was super confused in regards to the oem top hat and coil over spring plate..
So the oem bearing washer is the only thing you need between the two components ..
My kit did not come with end link bars. Do I need to purchase separately?