I’ve seen many ways to remove the emblems and I’ve tried many methods. I’m good with any method that gets the job done without damaging the car or scratching the paint.
Part Number for hood emblem: 51 14 8 132 375
Part Number for emblem retainers: 51 14 1 807 495 (you will need 2 of these)
Find the correct part number for your BMW here: https://www.realoem.com/
Did you learn something from this video? Consider Subscribing here: https://www.youtube.com/c/InTheFastLaneWithJamie
———————————————————————————————————————
**Subscribe Here: https://www.youtube.com/c/InTheFastLaneWithJamie
Jamie is the Owner of Elite Motor Works in Sarasota Florida, You can check out his business in the links below:
-TikTok: https://www.tiktok.com/@elitemotorworks
-Elite Motor Works Website: https://www.elitemotorworks.net
-Elite Motor Works Instagram: https://www.instagram.com/elitemotorworksfl
-Elite Motor Works Facebook: https://www.facebook.com/benzandbmwrepair
-Elite Motor Works YouTube Channel: https://www.youtube.com/c/Benzandbmwrepair
Hi Jamie, can you make a video on how to replace the emblem on the steering wheel of BMW X3 2.0d F25 (Jan-2015)? Or just give some instructions on how to do it? Thanks a lot !!!
Watching you scrach the car with the flat head made me tense my hole body
Easiest way I found is using an empty 1L plastic yogourt, or cottage cheese container. Cut a 1 Inch wide circular strip from the container. Then making sure the natural curve of the plastic strip faces down feed it under the emblem, same as you did with the strap. The natural curve keeps the strip down against the hood so it will easily come out at the other end. Then just grab both ends and pull it straight up.
60 cents a piece and they are CHEAP?
I like your first method, it made me cringe!
my jaw dropped to tha floor
If it is this hard for him then it is impossible for users.
Please put a trigger warning next time on the “how not to do it” video. It was obvious what you were going to do, but no amount of prep time was sufficient to get through that segment safely. Perhaps it was intensified as my e93 is in the same black and I’m sitting in front of my car as you used that screwdriver.
Thanks, Jamie. I followed the instructions to the letter and had the old hood ornament off in about 2 minutes. Super helpful video!
Its a bitch if the pins snap!
Nice video! I didn't have the clearance to slip that strap underneath. I could barely get the blue prying tool under but it worked eventually.
thanks a bunch. i'm going to try to put the classic badges on my 2021 X6.
Hi Jaime, thank you for your wonderful video. I have a problem. When I wanted to get out emblem unfortunately both pins are broken? How could I take out the pins? Thank you.
Only 60 cents? U sure thats a oem bmw part??
Lol "the right way"
fishing line works for me
"… use any cleaner that's safe for the paint of the vehicle" – proceeds to scuff the paint to hell …
Nice video. The only thing I would do differently is after cleaning the area under the rondel, is apply a coat of sealant or wax. But I understand that was just a customer’s car.
How about one on the trunk lid??
Man my heart sank on that one just full send on that hood lmao. I hope that was a throw away hood for that guy.
Some strong hot glue and yank
I normally get it up a bit, and use mechanics old friend some piano wire, wrapped around the edge and pull it off via a slide hammer.
I use zip ties to tie them to the vamos Solenoids in my m2 because theirs no room to pry them out so I tug them out