A DIY instructional video created by the BMW Motorrad Club of Northern Illinois demonstrating how to change out the rear rotor on a K1200LT. May apply to oth…
BMW K1200LT Rear Brake Rotor Replacement DIY
11
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
Great video. I was lucky that all the screws came out with heat. phew. No
drilling. Ordered the new rotor as per your recommendation. Good price from
US to Australia. Keep up the good work guys. Great videos
What about the ABS sensor alinement?
The sensor does not get removed so is self aligning when you put everything
back together.
I Thought some users may need a free chart from NM to LBS at: thetoolhut .
com/ Torque-Conversion-English-Metric .html
Just replaced my cowbell BMW rotor today with an EBC MD615 and new EBC pads
by following the instructions in this video. Worked out perfectly. Thank
you for a great piece of instruction.
Component Cooler #64-4321 – Cools to below –62°F, leaves no residue EBC
Replacement OE Rotor MD615 Loctite Threadlocker,(Red) 243 Loctite
Threadlocker (Blue) 242 21nm – (186 inch lbs) TY for all your videos..
Just bought a new EBC rear disc for my “new-to-me” K1200LT. This guide is
awesome!
I hade to look them up again.. Rotor to drive = 21nm/16lbs 5 Lung bolts =
(first to 50nm/37lbs) then to 105nm/78lbs 2 Brake bolts = 40nm/30lbs 3
small ABS ring screws = 8nm/6lbs (hand tight)
Just got my new rotor from EBC today.. I cant wait to put it on as soon as
the brakes come and say good by to the cow bell.. ty for all your videos..