This DIY shows the installation of BMW E60 angel eyes for the LEFT SIDE, i also have another vid for the right side installation!
BMW E60 angel eyes replacement installation LEFT side
42
Like
Save
){kind=link}
- Tags:
Angel, Eyes, installation, left, Replacement, side
- Categories: BMW
Comments
Write a comment
You must be logged in to post a comment.
somebody shoot the hammer man!!!
Thanks a lot will try this in 20 min. but gave me a ruff idea how again
thanks.
Thanks for this excellent instruction video! do know how to get work
bendlights or “curvenlicht” they has jumped off the groove sry bad
english……
Will this change angel eye color from yellow to white/blue/whatever color
you picked?
Should be same at my car? My car is bmw 525d 2005.? Thanks
como queda po awueonao.
helpful, thanks!
Yes
does one light bulb feed light to both angel rings
i’m guessing this is for LCI lights
Thanks for this excellent instruction video, the BMW dealer wouldnt tell me
how to do it and wanted car booked in for a rip off bill. The owners
handbook is no better showing scant instruction in miniscule diagrams. Top
man!!
Top one bro, Good Video… Some tool has a video up on here stating you
remove the wheel and cowling.
Is there only 1 bulb for 1 headlight housing? or do i have to buy 4 bulbs
to change color for all rings?
pre LCI you need 4 bulbs per side. LCI models you need one H8 per side
Brilliant video! One question, why do you have your pinky finger nails so
long? Is that part necessary for the install? lol
looks a little rough how you put it back in and it doesnt look like you
made the headlight fit back into the front 100%
Try and make a bit more noice!
after watching this video several times. I finally did the swap-out. didn’t
know how to take out harness at 1:18. so my headlights were still clinging
on to the hood. my hands were too big to fit inside the circle where the
bulbs were so that for me was a bitch!!!!!!! For the tools I had, I had to
remove the “hood-latches” that run across the front of the hood because
they were in the way of the bottom screw. make sure the new LED marker is
properly tighten down. eyes appear dim if not.
Nice work. Thanks for the helpful demonstration.