Installing new Camshaft Position Sensors in my 2001 BMW 540i with the M62TUB44 engine. BMW Part #: 12 14 7 539 166 Approximately $210 from reputable online s…
Installing new Camshaft Position Sensors in my 2001 BMW 540i with the M62TUB44 engine. BMW Part #: 12 14 7 539 166 Approximately $210 from reputable online s…
You must be logged in to post a comment.
){kind=link}
Can’t hurt
I heard you are suppose to clear codes after you do this?
13 62 1 433 567 is the mass air flow sensor…. 12 14 7 539 166 is used for
both Cam shaft sensors
A bad camshaft position sensor can also lead to: change in exhaust note
(blatty sound) lumpy idle SES light on car running rich
Thanks a lot for the video!
You have replaced both sensors and I was wondering why you decided to
replace the two of them? Did the ECU see errors in the two?
did you get any codes ??? mine gave me P0020 intake camshaft position
actuator circuit/open bank 2 please let me know
hello, i can give u 1 symptom. if the car randomly goes off when you drive
(motor goes off), and it doens’t want to start. When my car just randomly
cut off the engine (electric still works) and it stopped the engine, i
couldn’t get it on again how much i try’d to start my engine up again. 2
Sensor’s where faulty; Camshaft Crankshaft after these replacement, my car
works like a charm!
To e39source did it improve throttle response
I didn’t have ECU errors, but I decided to replace them preventatively.
Thanks for the vid but I have a question what the symptoms to promt you to
change the sensors ?
Thanks ugur.
Thank you for noticing our flaw. Appreciate the feedback! Fixed.
Looks like you had very leaky valve covers in the past. I need to make an
M5 video on this procedure too. My intake bank 2 CPS is gone (has been
intermittent since the summer) and it is a different process, as we have
both intake and exhaust CPS’s and they are located in the back of the
engine.
what symptoms did you have that made you replace the CPSs?
hi there great video thanks can you please help me i got bmwx5v8 camshaft
position sensor in my car looks same as your old ones there is a step in
the sensor. head measures 11mm but the new ones measures 18mm & the ones
you fitted new looks same as ones that does not fit in my car new part no
is 12147539166 seems much to wide to fit in hole my old no is 1438083 i can
not locate any ware same as the old ones you have taken of please any info
be very appreciated thanks again ali