www.EdgeMotors.com
please like and subscribe
In this video we show you how to replace a crankshaft position sensor on 3.2L Audi A4 A5 A6 Q5 engines
Edge Motors
107 E Railroad ave
West Haverstraw NY 10993
(845)269-38-46
service@edgemotors.com
Audi A4 A6 Q5 A5 Crankshaft Position / Engine Speed Sensor Replacement DIY by Edge Motors
17,757
Like
Save
){kind=link}
- Tags:
Audi, Crankshaft, Edge, Engine, Motors, position, Replacement, Sensor, Speed
- Categories: Audi
Comments
Write a comment
You must be logged in to post a comment.
hi u guys are the BEST i have question videos any diy on replacing valve cover gaskets a5 3.2l also i have 181k on my 09 a5 3.2l 6 spd manual, im getting jurk or misfire not always and only around 3000 rpm any sugestions thx again
Hello
I have Audi A4 2003 3.0L V6 and get engine light and trouble code P0343 camshaft potion sensor "A" circuit high
I did watch your video how to location camshaft sensor, but i would like to know my car it is the same location? before i put hand on it, Pls give me advise. thank you
Can these be the cause of my car not cranking I have the epc light on
Awesome!!! Great job man!! Thank you..
You have done an excellent job a filming thank you!
Any videos on a6 c6 fuel filter and fuel pump replacement? I looked and found nothing. Thank you
Hi, do you have the video, how to change Oil Housing Gasket on 2005 Audi A6 3.2 FSI. Thanks
Can a bad or cracked electric connector to the crankshaft sensor play part in in the code p0335 to come up? And can a no name after market Crankshaft sensor have anything to do with throwing off the code and causing the 2 second crank before it stars ?
Thanks for the video again. It helped me remove and inspect the sensor. Not scratched from the flywheel. Maybe the space is too large
how do you know when it needs replacing?
Thanks for the video! Is this bank 1 or bank 2?
That's great!!! Thank you for taking the time out to make a quick video. Any suggestions on what to do or check for if the code comes up again after replacing the crankshaft sensor? Or if my car still has to crank for about 3 seconds before it turns over?
Thank you