Replace the stock cheap rubber boot ASAP! with either the factory honda boot or the energy suspension polyurethane boots(Trying out right now) Use a marine g…
Honda/Acura Front Camber Kit Ball Joint Boot Replacement
16
Like
Save
){kind=link}
- Tags:
Ball, boot, Camber, Front, Honda/Acura, joint, Replacement
- Categories: Acura
Comments
Write a comment
You must be logged in to post a comment.
how is working right now?
no
Hey do you have to remove the ball joint in order to replace the boot in
the lower ball joint. I ripped one when removing the lower control arm.
Thanks a ton. I also have the ES bushing kit.
What if I don’t replacing the ball joint?
Can you use aftermarket ball joints with OEM control arms ?
thanks for the help/info. i found out on h-t that the es bushings leak. i
tried to post the link but utube wont let me.
hey i got a question! i bought a set of mugen front camber kit and the ball
joint have gone out! so i found these skunk2 ball joint ….will it fit?
@roynae05 jhpusa
I bought these a long time ago under the name revo technica.Now they are
all over ebay for cheap
@r0k088 revo technica
are those ebay camber with blox replacement ball joint ?
@STHEEVYaJMUZIC if the ball joint is not worn out you don’t have to replace
it.if it is worn out sooner or later you’ll be driving and its going to pop
out
how u put the boot in and did you put any grease in it and it doesn’t pop
out?
Replace just the boot if its not ripped! If its ripped and you’ve been
driving it for awhile change balljoint
They don’t leak had them on my car for years
@juliogonza so far so good.I plan to take them off to see if any water got
inside
energy suspension polyurethane problem solved no more ripped boots
@waltseg6 Remove the nut on the end of balljoint then use balljoint removal
tool or ball peen hammer to pop ball joint out.remove old boot clean off
old grease.put new marine grease on balljoint and inside the boot.install
back onto balljoint.when you tighten the balljoint it holds the boot on the
balljoint.Why would it pop out?
where did you get the replacements
Just pop out ball joint from lower arm and install thats all
them boots still holding up? im tired of ebay UCA balljoints dying 3 months
later
do you have to replace the entire ball joint or can you just replace the
boot?
Where did you get the balljoints that you used to replace the ones that
came with your Camber Kit?
@s3xybitchj3ssie BLOX REPLACEMENT BALLJOINTS
thanks for the help/info. i found out on h-t that the es bushings leak. i
tried to post the link but utube wont let me. can you give me the part
number for the oem honda ball joint boot please.
I have no idea
you just adjust the sliding balljoint so the camber is even on both
sides.You should check your tie rods you might have toe wear