DIY:Replace Transmission Mounts on Honda Acura Accord Odyssey Pilot Cl MDX TL with a 4 or 5 speed transmission.
Make sure you remove the bolts for the front motor mount from the top, they are 14mm bolts. Don’t do what I did and remove the welded nut from the bottom of the front engine mount.
Crushed by a car and lived interview:
https://youtu.be/5t_fb_fLjc8
Transmission Mount Replacement
Vehicles Include:
1998 Honda Accord
1999 Honda Accord
2000 Honda Accord
2001 Honda Accord
2002 Honda Accord
1999 Honda Odyssey
2000 Honda Odyssey
2001 Honda Odyssey
2002 Honda Odyssey
2003 Honda Odyssey
2004 Honda Odyssey
2005 Honda Odyssey
2006 Honda Odyssey
2007 Honda Odyssey
2008 Honda Odyssey
2005 Honda Pilot
2001 Acura CL
2002 Acura CL
2003 Acura CL
2001 Acura MDX
2002 Acura MDX
1999 Acura TL
2000 Acura TL
2001 Acura TL
2003 Acura TL
Music by Randall Kent: As seen on NCIS
https://youtu.be/iYwsjia4GtI
All Rights Reserved 2016
© Copyright 2016
Bundys Garage
All rights reserved. This material may not be published, broadcast, rewritten or redistributed in whole or part with out the express written permission. Contact: bundysgarage@gmail.com
DISCLAIMER – DISCLAIMER – DISCLAIMER
Due to factors beyond the control of BundysGarage, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. BundysGarage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. BundysGarage recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of BundysGarage, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the end user and not BundysGarage nor any of it’s subsidiaries.
){kind=link}
does someone know how many transmission mounts theres in the Acura tl 2006 ?
why don't you tell us what the whole set cost you on rockauto.com? don't forget to include shipping
Awesome video, man! I did the front a few days ago on my wife's Pilot. Wish I had known I needed to loosen the front to do these. I'd have done them all the same day. DOH! I'm hoping that I can just loosen the top nut that connects the engine bracket to the front mount. LET'S HOPE!! I think I have about 5/8" of play there.
Thank you for the video. I started to put a wrench to those front, welded bolts and then I remembered your mistake and saved my efforts for other things. Also, thanks for pointing out that hidden bolt on the front transmission mount – I couldn't see it but thought something was there and watched this video. I still had to do the work, but you really helped on this one.
Should the rear motor mount be loosened like the front one in order to raise the engine up?
after raising the trans. and removing the old mount, do you have to move the trans. up or down or horizontally to re-align the trans to the sub-frame so that the new mounts can fit into all holes for the nut engagement.
dude, you could crush your fingers or hands if you're not careful..