DIY/ How to remove the front bumper on 2009-2013 Acura TSX. 2nd generation CU2/ Accord Euro. 2009, 2010, 2011, 2012, 2013 Models.
DIY/ How to remove the front bumper on 2009-2013 Acura TSX. 2nd generation CU2/ Accord Euro. 2009, 2010, 2011, 2012, 2013 Models.
You must be logged in to post a comment.
lol mouse voice 1234567 hahaha
Is there vtec even tho it doesnt say so on the motor?
I haven’t done it but I would say yes. If you can remove the bumper, then
removing the grill is pretty self explanatory after the bumper is off.
Is removing the grill from the bumper pretty simple?
Nope, In the instruction manual it will tell you how to without removing
the bumper. You need to remove a couple clips on bottom of the bumper, on
each side. Then there will be a black plastic flap that opens to change the
bulbs.
Would you need to remove your bumper to change fog lights? Is there any
other way
can do you a video on how to clean the engine areas? or no? thanks
You mean just under the hood? I like to vacuum all the left over leaves and
derbies, then wipe everything down with a moist soapy towel. Hope that
helps!
So you want it so that your fogs are on during the daytime while your DRL
are on? Or you want your DRL are on at night when the fogs are on?
To be honest I’m not entirely sure what’s a good method of doing this. I
don’t want to put out any unconfirmed information here, so I’ll send you a
PM and help you the best I can.
alright thanks man
basically i want my DRL off and have the fog lights run as DRL. so the fog
lights are on at all times. if thats possible, thanks
Great video! Can you do a tutorial on how to wire your DRL on to your fog
lights. I’ve read the written tutorial but I don’t understand. If you can
make a video that would be much appreciated! Thanks!