Acura RSX Type S Coilover install

Acura RSX Type S Coilover install

This is a Basic coil-over replacement of the springs on a RSX Type S model car I didn’t see any videos of this done on here and it’s was something I was doin…

37
Like
Save


Comments

jjmax2007 says:

yea only if u have both parts ready to be installed, no if u have rims dont do the coilover first do the camber kit so that when u do the install with the rims u can already have the camber installed

jjmax2007 says:

plan on getting a sticker bomb soon, not pain will post a vid when it’s done

Evmaomar says:

Would you suggest doing the coilovers first then the camber kit ?
So then you wouldnt have to take the camber kit off and on again ?

MisterDubzDC5 says:

Are you going to paint your lip kit? It’ll look good with lips painted and some new wheels.

Alex P says:

dang for real? what happened? i installed some D2 coilovers like a month ago or so. I found them on craigslist for 600 but i got em for 520 and they ride really good. you could probably try that next and find a good manufacturer used.

jjmax2007 says:

CRX Brand.. not really sure what it stands for, and no i am using the same tie rods… just got an alignment..

jjmax2007 says:

this is awesome thanks for this…….

jjmax2007 says:

They Ride Awesome…. but i learned after install that amazon don’t really have reliable parts : /

Kenneth Roman says:

what coil overs are these?? and did you need longer tie rod ends???

Alex P says:

33 ft/lb torque on the FRONT page 18-23 in 02-03 service manual
43 ft/lb torque on the REAR page 18-35 ” ”
if you got a different year i would double check.

Alex P says:

Nice buy! How do they ride?

jjmax2007 says:

There you go….

jjmax2007 says:

Sure my speakers are going bad, and they are bose i don’t want to but i will soon stay tuned

jjmax2007 says:

it’s recommended but you don’t really have to unless it’s a big enough change….

jjmax2007 says:

i have other videos with parts being installed in the trunk check out the page it might help a lot, but i have bars in the trunk can’t really make one that would help…..

Bassinmytrunk713 says:

@Rene Rodriguez look up rsx speaker install the 2 video down shows u how to

Bassinmytrunk713 says:

@Rene Rodriguez look up rsx speaker install the 2 video down shows u how to

Rene Rodriguez says:

Can you show how to install speakers in the RSX, like taking off and putting the door panel on? Pleaseee

Eriks dc5 says:

Do you need an alignment everytime you adjust the ride height?

Bassinmytrunk713 says:

@AokieDesigns optional if you want it or not. Sum ppl get it make their wheels sit as straight as possible after lowering their car.

Bassinmytrunk713 says:

And now I can’t put the trunk together***

Bassinmytrunk713 says:

I have a 02 rsx and put skunk2 suspension and had to take apart the whole trunk. And now I can put it back together can you make a video on how to re assemble the trunk carpets??

AokieDesigns says:

I have a question if you lower your car do you have to get a camber kit

jjmax2007 says:

Noted, plan on this vid some time soon they are needed for the car

jjmax2007 says:

depends on where you live but this car was 212.89

jjmax2007 says:

and amazon…

mike schlaker says:

ebay cx racing

mike schlaker says:

make a how to install side markers or headers or exhaust?

mike schlaker says:

hey how much did your life time alignment cost??!!

iOS Fan says:

Link? Or web site. Thx

Write a comment