Boat throttle cable and boat shift cable replacement and measurement.
Boat Throttle and Shift Cable Replacement
28
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
Boat throttle cable and boat shift cable replacement and measurement.
You must be logged in to post a comment.
On my older Morse steering cable, it has a tilt tube threaded into a block
for adjusting it. After replacing the cable using the old steering tube, I
noticed the end of the tube allows a lot of grease to come out when
steering. How can I keep the grease in? Can I use the little rubber boot by
Teleflex that has the felt insert in it?
i have to post a video out here. i’m having trouble removing the steering
cable from the actuator. it has a stop or something in there and wont pull
out. does the cable screw out? Is the actuator a one-piece attached to the
cable? do i have to order a cable with an actuator? seems unlikely. Plus
on the other side of the actuator there is another cable end and it appears
to be separate from the one on the ‘steering/starboard’ side of this boat
entering the actuator.
Each is pinned to hold the cable end. the port side is connected to the
outdrive ‘u’ arm with a pin. the top of that arm has been compromised by
corrosion and the pin is held like a weld in it. I cannot remove that pin
without breaking the top of that connector ‘u’ from the outdrive. it’s a
Sea Ray Sport Cruiser with a 5-liter mercury and has an Alpha One
outdrive/sterndrive.
before i got there the customer cut out the rack and cable down just before
it goes into the actuator. the remaining cable is hanging out of the
actuator and that is what i cannot remove. also if i break the top part of
the connecting arm from the outdrive, is that piece replaceable? i cannot
remove the actuator without getting this pin out. i can send a video and a
few pics if that will help.
any help appreciated.
Ray
okay maybe someone can help me i have a 88 hp evinrude my problems is that
it will not idle in nuetral and my fast idle rpms are low if you let the
fast idle down it dies but if you put it in gear at just the right time and
give it throttle the engine runs fine is this a carb problem or do i nee
new cables the engine runs fine and plane off fine
I need a video on how to get the cables out of the shift control box?
Everything else is easy.
im trying to replace the boat cable to the transmission switch on my
evinrude 35 horse.i cant figure out how to remove the cable from the
housing.i took the housing apart, and have that half of the housing, still
attached to the cable, and there seems to be no way to simply take of the
cable..need help
I have a 35hp evinrude don’t know the year but need help with throttle
cable the one you put forward,neutral,reverse
I have 2003 60 hp mercury im havin problems with the alarm system an the
control box the alarm system is shuttin down boat please emil me any
troubleshooting you may know I could try
Rebuild the carbs.
Debbieburnes@gmal.com
Boats are a pain in the butt.