Raise & support the vehicle safely according to Manufacturer Jacking & Supporting Positions!!! **** Rate, Comment, Share, Subscribe, Let the Ads play……
VW A4: New Beetle Headlight Bulb Replacement
5
Like
Save
){kind=link}
- Tags:
Beetle, Bulb, Headlight, Replacement
- Categories: Volkswagen
Comments
Write a comment
You must be logged in to post a comment.
Great how to vid! Thanks a lot!
I haven’t tried to move the lever yet but I’m sure it’s not going to be
easy to do when I have to. It was the 1st replacement so I’m sure they did
do it but they’re under new management now so I have no recourse with the
shop. Do you think the lever will move without being able to push in on the
tab? Yes, metal would have been much better in an engine compartment for
anything needing to be pushed, pulled or turned!
There’s usually always an issue when pulling one of these, regardless of
which side. Thanks for watching!
No problem and thank you for replying to my replies!
Forgot to say, Thanks for your time on video and replies!
Thanks man, most don’t show the driver side. Very well done!
Only now saw the comment… It’s actually a nice & simple design, when
things work as they should!
Are these assembled by Oompa Loompas? What if you have ham fists?
My issue after I went and looked at both headlights is that the shop that
replaced the bulbs 2 years ago busted out the tab that you’re supposed to
push in to release the lever! Lights are good right now but how am I going
to move that lever in the future with the tabs punched out?
I see many that have something broken… plastic components are not great
in the long run. If I break someting, I tell the customer. Chances are that
it already was broken.