You could loosen that 30mm nut while the tire is still on the ground. You won't have to stop it from turning because the weight of the car will keep it from turning. You can also use a hand held Impact Driver to loosen the nut.
Thanks for this video, Peter Finn. I have the Toyota 2001 Corolla, I replaced drivers left side half axle. Thanks again for this video very helpful to me.
nice video I actually used this to do my corollas axle. But I have this wobbly effect when I put the vehicle on drive and its coming from the driver side inner axle where it connects with the transmission any ideas on what can cause this
can an ae100 cv joint fit and work on an ae 110 ???
did u drain out the transmission fluid first?
thank you very much for taking the time to record and teach us how to remove these parts. keep up the good work.
You could loosen that 30mm nut while the tire is still on the ground. You won't have to stop it from turning because the weight of the car will keep it from turning. You can also use a hand held Impact Driver to loosen the nut.
my passenger side drive shaft jiggels a lil bit what could it be and I fond a like 3in bolt….
Thanks for this video, Peter Finn. I have the Toyota 2001 Corolla, I replaced drivers left side half axle. Thanks again for this video very helpful to me.
What year is it
thanks for this video…
new tires balanced but still have driver side inner axle shaking could it be bad differential bearings?
nice video I actually used this to do my corollas axle. But I have this wobbly effect when I put the vehicle on drive and its coming from the driver side inner axle where it connects with the transmission any ideas on what can cause this
you are absolutely amazing thank you for this!