Here is a very detailed guide on how youcan replace the outer or exterior door handle on your Toyota Camry, I go through every step including how you can remove the interior door panel, how to disconnect all the connecting rods from your lock actuator and all the nuts and bolts you’ll need to remove before being able to take this handle out and replace it.
Where can i get those 10 mm screws from i lost mines
Why don't your REPAIR-VIDEOS PLAY, have had this problem MORE than once !!
How about a Lexus rear door handle, that will not open from the outside.
good video showing all the steps…also good idea with the paper towel….only thing though, instead of going to the junk yard for a used part, buy a new one off amazon for $8 ….make more repair videos!
Great tutorial, thanks man!
Nice video. Did you have any difficulty re-inserting the door's rod back into the plastic grommet? It was a challenge to remove / unseat and I am having great difficulty re-inserting it.
Thanks for your tutorial! I noticed your window is sometimes up and sometimes down, changing positions between steps. Would you please add notes describing why and when to roll the window up or down?
Bought a replacement handle for $8.50 off ebay and installed myself. You saved me some money and I really appreciate it!
very nice….does this work the same for the 1997 tercel? should be easier cuz i have manual crank roll up windows
Very Good Tutorial! Made the repair very easy! thanks for the tip about the paper to hold the screw in.
What about installing a 2004 Toyota highlander passenger door handle
This one the most detailed and concise i found so far. I like this video. 😀
I wonder if broken piece can be fixed by epoxy cement. Will try that later.
Thank you so much! Just replaced Avalon 2002 door with the help of this video!
Thank you very much, this useful video.
My back door on my Camry won't open from outside or in how would I fix that ?
Nice job on the video! Thank you!
Another trick – connect the lock cylinder actuator lever and retaining tab before reinserting the door handle.
Liked the paper towel method at 6:30
Nice, detailed tutorial with clear images – well done!
Thanks for this video. It was well explained and touched on the important aspects of the task.
After watching the video, I was able to replace my driver side door lock successfully.
Think of the cost it saved me!
changed all handles on my wheels thanks again man
great tutorial man, easy to follow and clear.
lost the screws inside the door frame. any easy way to retrieve it other than a magnet extender?
Very helpful I have three doors that need new handles this makes it seem a lot more simple than I thought i had one of those plastic brackets for the interior latch snap so I had to rig it up to the handle but works OK now I hated having to roll my window down to let myself out