How To Install Replace Power Window Regulator Toyota Sequoia 01-04 1AAuto.com

How To Install Replace Power Window Regulator Toyota Sequoia 01-04 1AAuto.com

http://www.1aauto.com/1A/WindowRegulators/Toyota/Sequoia/1AWRK00515 1A Auto shows you how to repair, install, fix, change or replace a slow, stuck, cracked o…

7
Like
Save


Comments

1A Auto Parts says:

@WhoooLovesOrangeSoda The process will more than likely be different
between models. The basic procedures though, such as removing the door
panel, taping up the window up and unbolting the window would be the same.
Hope this helps you out. 1aauto.com

Douglas Johnson says:

Great video. I used this video for my 2000 Sienna – almost the same.

Jorge Quezada says:

Hi Mike, My rear hatch window on my 2002 toyota sequoia won’t go down. I’m
assuming the regulator/motor isn’t working anymore. Is there anyway you can
post a video on how that can be replaced? your videos have been very
helpfull in the past replacing door handles. Thanks.

WhoooLovesOrangeSoda says:

Is there a similar process for all 2001+ Toyotas or is there a new
significantly different design?

john shields says:

My 2002 Toyota Sequoia drivers side front window sometimes rolls down and
sometimes dont, so how do I know if I need to replace the regulator?

1A Auto Parts says:

We’ll keep this in mind in the event that we need to make this repair.

1A Auto Parts says:

HI John, Check the wire harness that runs between the drivers side door and
body of the vehicle for a broke or frayed wire that may need to be
repaired. if the harness plugs into anything, make sure that those
connections are secure. Hope this helps you out. 1aauto.com 888-844-3393

Write a comment