How to install component speakers in your 2005-2015 Toyota Tacoma Double Access Cab. Using the tacotunes.com wire harness adapters, speaker adapters and tweeter adapters you don’t have to make any permanent modifications to your Toyota Tacoma
How to install component speakers in your 2005-2015 Toyota Tacoma Double Access Cab. Using the tacotunes.com wire harness adapters, speaker adapters and tweeter adapters you don’t have to make any permanent modifications to your Toyota Tacoma
Comments are disabled for this post.
What is the part number for the green plastic tabs that are for the bottom speakers. Thank you.
Do you guys have a video for the JBL system 03-09 4Runner?
Hey bro i bought these speakers for my Toyota Tacoma. I want to get the most of them. Do you think I should get an amp for them? And a line out converter? I do not want to add subs so would that matter? I’ve watched all your car audio videos by the way. Thank you for everything
Is there a way to mount speakers in the access door in a 2013 Tacoma the speakers are currently in the ceiling
I purchased these and installed them using this video. Worked great and my Tacoma sounds a lot better. Thanks guys! Good review from me
This dude stresses me out for some reason.
How would you connect the crossover for the front door in a Toyota Tacoma 2008 base model? Would I be connecting from the factory tweeter cable like mentioned in this video or from the factory speaker wire that was ignored? (which I saw in another video, although the vehicle was not a Tacoma) I will be doing a speaker install tomorrow so I hope you can see this in time lol.
I did research and found out that right after the factory harness to the tweeter, if you rip off rye heat shrink. You can see that the wires run in parallel and you can cut the wires after the parallel right at the old tweeter and then run those two wires too your crossover
Why not show how to do it in single cab nobody gives my truck any aftermarket love man , I have to figure it out through trial and error
What is the process if you are installing components with no crossover?
Please help, I bought a 2015 Toyota Tacoma TRD off-road Access Cab. I recently had an SR5 Toyota Tacoma. The excess cab has no speakers in the rear. Only 2 tweeters and door speakers up front, I would like to put a subwoofer between the two rear foldable seats or some speakers in the doors. I have no idea how to do this since there are no existing wires and no speakers to replace where do I start and what do I need and what do you suggest?
Wait. So why cut the connectors off of the tweet wire?
Also. I ordered this exact kit and it didn't come with zip ties or speaker cable. I like the kit, but I've had to make 2 runs to the store for ties/cables. Also the tweeter mount was way too big. I wrapped lots of electrical tape around it. Probably 3-4 feet on each one.
Can you make a video on how to remove the rear cab speakers in a 2001 Toyota Tacoma? I can't find one video on YouTube on how to do this
No amplifier for the component speakers?
2 part epoxy for the tweeter mount???
No soldering?