DIY How to drain and fill coolant 2005 Toyota Matrix Corolla

DIY How to drain and fill coolant 2005 Toyota Matrix Corolla

1999 2000 2001 2002 2003 2004 2005 2006 2007 2008 Toyota Matrix Corolla. Engine: L4-1.8L (1ZZ-FE). Owner accidentally mixed with green coolant. Certified Use…

27
Like
Save


Comments

88bmyvegas says:

only a cup is odd but thats ok. teflon is ok too. no leaks is good but drive the car for 20 minutes, if you see the temp gauge goes over 3/4 to hot then you still need to add coolant because there is air still in the block. sorry late reply, gone to a car show.

rhino11us says:

88, i took the whole thing out and only a cup of coolant came out???? i didn’t have loctite but used teflon tape will this be ok. i’ve been heating, cooling engine and filling radiotor. tomorrow morning hopefully one last top off. i can’t see any leaks from plug. TY

88bmyvegas says:

you can remove the whole thing but when coolant is removed, put locktite on the threads when you tighten it back so it will not get loose and leak. welcome

rhino11us says:

i couldn’t get a wrench from above as I can turn the 10mm bolt from above on the corolla. from underneath i had a hard time to reach. i tried to tighten base back but left at 1/4 turn. do you think it will leak? should i just remove the whole thing? TY.

88bmyvegas says:

i think it is better to use a 12mm wrench(i think that’s the size) to hold the base of the spout.

88bmyvegas says:

try holding the the spout with pliers, then loosen the bolt. try that. tell me what happens. welcome

rhino11us says:

hey 88, i’m doing the job now but the rear block drain is turning with the 10mm bolt. any advise, i’ll wait to see if I get a response soon. TY.

88bmyvegas says:

Camilo, Thank you for the comment, I really appreciate it. Makes me feel good to know people out there appreciate the videos I have. It takes time and patience to make the video. Trust me, It’s not easy to do “how to” video’s. If only I had a third arm and eye, LOL!!  Welcome and please subscribe. Have a nice day.

Camilo Sánchez says:

Excelent video 88myvegas! Best video on youtube on how to change the coolant. Also I’m amazed with the comments you give to people. Really helpful. Thanks!

88bmyvegas says:

you would have to keep on pouring coolant into the radiator when you see it go down. if it it topped off and see no more bubbles and can see steam coming out, put on the cap. but watch the thermostat gauge on the instrument cluster. this process can take up to 15-20 minutes till the thermostat opens and the radiator fans go on. anymore questions please ask.

rhino11us says:

how do i get all the air out if i don’t have that big funnel you have? thanks.

88bmyvegas says:

what is the coolant color now?? is it red or green?? if it is red, you would have to buy the coolant from the dealer. If green then you can get it at the parts store.

rhino11us says:

i’m about to change coolant. do I have to go with toyota coolant. prestone is selling one that says that for all makes & models. thanks for the video.

88bmyvegas says:

no it does not have a bleeder valve. highest part of the cooling system is the radiator radiator cap. you would need to keep on filling it till there are no bubbles.

rhino11us says:

does the corolla have a bleeder valve after you fill it with coolant?

88bmyvegas says:

welcome, glad you like it. Have a nice day and please subscribe.

Maxwell Castro says:

WOW very helpful video, Thank you so much, also i loved the video editing it was slightly comical.

88bmyvegas says:

welcome, you have to drain at two place. first at the bottom of the radiator and on the engine block. you have to do it only from the bottom, it’s very hard from the top. thank you and please subscribe

zech007 says:

Arent your suppose to dilute the coolant with distilled water? I dont recall Toyota selling prediluted 50/50 coolant

Taxminia0311 says:

I located two days ago when I had to change my manifold gasket thank now all I have to do is remove the serpentine belt to change the water pump and thermostat at the same time, like the saying is said “kill two birds with one bullet” lolo thanks

88bmyvegas says:

thermostat is on the lower radiator hose that is connected to the engine block. you will have to remove the alternator to get to it. remember to have jiggle valve on thermostat upwards. thanks for asking and please subscribe

88bmyvegas says:

give me a couple minutes and i will check

Taxminia0311 says:

Do you happen ton know where the thermostat is located on a 2003 Toyota matrix Xr Automatic FWD???

Juan Ramirez says:

This is one of the best coolant drain in fill videos for a toyota on youtube. Most people are stupid and buy radiator flush and pump their cars with water. Also good job draining the engine drain plug. That’s another thing that everyone manages to avoid.

Write a comment