Car Fix DIY Videos

Parts used linked in the description below!

Watch a full tutorial as a 2020 Toyota Corolla will have an amplifier and subwoofer installed. We will be installing our amplifier under the driver side front seat and integrated to the factory audio sound system.

NOTE: Our corolla was not equipped with the upgraded JBL amplified audio system. IF you have JBL, you will need to tap into the JBL amp with the harness linked in the description below for your audio signal.

This video applies to Toyota Corolla models for years 2020, 2021, 2022, 2023 and newer. NOTE: this process can be done for corollas with the earlier generation (2014, 2015, 2016, 2017, 2018, and 2019) however the dash design is different when installing your line out converter to the factory audio system. This video also includes kick panel removal, complete installation for the powered subwoofer / amp, wiring, and testing!

Click here to see how to set your gains on an amplifier: https://youtu.be/hOV3ngPnMdM

If you have any questions, leave a comment below! Be sure to like and subscribe!

Parts Used (Amazon Associate / eBay Partner Paid Links):
*Skar Audio 10: SDR DVC 4 Ohm Sub: https://amzn.to/3njZrmi
*Atrend 10″ Subwoofer Box: https://amzn.to/3se5pGg
*JL 500w RMS 500/1D Amplifier (Discontinued)
–Recommended Amplifier: https://amzn.to/3qz3k73
*8 Gauge amplifier wiring kit: https://amzn.to/3iWX7jK
*Pac LP7-2 Line out Converter: https://amzn.to/33lRh5u
–Optional Full Pac T-Harness (non JBL): https://ebay.us/CgE3YE
–Optional Speaker wire T-Harness (non JBL): https://amzn.to/33reILj
–Optional Full Pac T-Harness (if you have JBL): https://ebay.us/qREPtN
*12″x16″ ABS Plastic Sheet 1/8″: https://amzn.to/34W9TtW

Disclosure: As an Amazon Associate / eBay Partner I earn from qualifying purchases