Yea I did this and it has power out of the condenser and and on/off switch but there is nothing out of the plug boot. Is that normal? I’ve never tested a coil before
Three to five….hundrwd, thousands, ten thou? You also have to check primary resistance from the wire to coil ground. Testing coils this way isn't accurate. Disconnect the small black wire off the coil. If it sparks your small wire is grounded or the on/off switch is bad. If she don't spark inspect flywheel magnets and test for magnetic strength. If its good replace coil.
hey man i have a 1988 ct 200 and it has this problem where it will start and run for a second then stall. revving the engine does not help, carb is spotless so i know it’s not the carb. honestly so stumped do you think it could be a bad coil? seems like the more i try to start it the harder it gets to start.
){kind=link}
Wish you would have gotten more in the video then some of it off camera lens
Pick up coil
But how do u tell if it's bad also can it be half way working or a weak spark or not it does it go all the way out and stop working
You didn't tell the viewers where to set your voltmeter, you're basically assuming everybody knows how to run a voltmeter I do but not everybody does
"and I'll be showing you how ta testicle"
Should the Ohms decrease to zero after a second or 2?
You checked the low tension coil but you didn't check the high tension coil .
Gotta know the ohm's of it cause continuity don't mean shit!
Yea I did this and it has power out of the condenser and and on/off switch but there is nothing out of the plug boot. Is that normal? I’ve never tested a coil before
Three to five….hundrwd, thousands, ten thou? You also have to check primary resistance from the wire to coil ground.
Testing coils this way isn't accurate. Disconnect the small black wire off the coil. If it sparks your small wire is grounded or the on/off switch is bad. If she don't spark inspect flywheel magnets and test for magnetic strength. If its good replace coil.
3 2 1 0.0 reading?
My quadbike only sparks when the spark plug is not grounded, when i do ground it. There becomes no spark
00.0 reading ? good or bad?
What if my ignition coil has two prongs? I have a 95 and I think my ignition coil is going out. I have spark but very weak and not enough to ignite
hey man i have a 1988 ct 200 and it has this problem where it will start and run for a second then stall. revving the engine does not help, carb is spotless so i know it’s not the carb. honestly so stumped do you think it could be a bad coil? seems like the more i try to start it the harder it gets to start.
How do you know is "3 or 4" and what unit are you testing for? Amps/ohms?