Saab 9-5 Aero Fuel Upgrade Install

Saab 9-5 Aero Fuel Upgrade Install

Upgrading the injectors and installing a better fuelpump.

For sure the car doesnt run as it should, the injectors are twice the size of the oem ones 🙂

Follow me on Instagram:
https://www.instagram.com/jonaskakarikas/

8,948
Like
Save


Comments

jean raschella says:

Hi i have a saab 9.3 2001 running whith ethanol ,i check my injectors and i see the caps joints is gones burn by the ethanol .There is a solution upgrade.i want to start in stage 1 .thanks for handsers.jc

Per-Arne Sundell says:

Var har du köpt tröjan?

M Lind says:

What is the kit?

M Lind says:

Pantera – Hollow 🙂

Dan SJK says:

good taste in music 😉

Eric Beard says:

Thought you had to run in in 3rd gear for awhile and it resets?

James says:

Any tips on inserting fuel injectors?
One I heard to dip the top tips in gasoline before install into the rail.
Second I heard to put Vaseline on the bottom tips before install into block.
Getting ready to change my fuel injectors and I am not sure proper technique.

olegop1988 says:

хоть и не знаю вашего языка,но интерестно смотреть)))

Pedro Fox says:

5:00 You also seem to lack the retaining bracket that holds the fuel lines on place. My pressure line (9-5 from 2005) jumped out somehow and it started to smell gasoline. Then I discovered the car was leaking gasoline. Probably it flooded the area where the pump can be seen and it then went down between the chassis and the tank. Some models seem to be missing the bracket and I also seem to have some red paint where the middle torx screw is. Hopefully I can attach a retaining bracket there and perhaps you should too.

Sterlin876 says:

I subbed to this channel like a year ago and it now shows up as I am not subscribed anymore. The algorithm of Google….

Danny Jr says:

Guess I'm removing that bracket soon bc I need to swap injectors. Thanks for these videos!

Mr Toad says:

How did you support the wiring loom and lambda sensor plugs without the support bracket?

saab says:

Hi, do I need to register new nozzles in the program? Is this mandatory?

Comments are disabled for this post.