I did mine a week ago. This is not as easy as it looks.1. All the nuts and bolts come in a bag. The directions tell you where each bolt goes but, you have no idea how to tell one from another..2. The air intake tube was difficult. I had to add a bolt to the bottom of the shield to try and wedge it to stay upright.3.The tensioner and idle pulley were rubbing the back of the shield. Had to exchange to a flat bolt at oil fill and hammer a round notch so tensioner pulley wouldn’t grind. 4 hours…
Does not matter if you have manual or Tip. This install is great. If you replace more than just the intake system. Like exhaust etc.. You will have to have the computer remapped due to timing issues and air/fuel mixture changes.
){kind=link}
I did mine a week ago. This is not as easy as it looks.1. All the nuts and bolts come in a bag. The directions tell you where each bolt goes but, you have no idea how to tell one from another..2. The air intake tube was difficult. I had to add a bolt to the bottom of the shield to try and wedge it to stay upright.3.The tensioner and idle pulley were rubbing the back of the shield. Had to exchange to a flat bolt at oil fill and hammer a round notch so tensioner pulley wouldn’t grind. 4 hours…
what is the sound like please..
Does not matter if you have manual or Tip. This install is great. If you replace more than just the intake system. Like exhaust etc.. You will have to have the computer remapped due to timing issues and air/fuel mixture changes.
Will this filter make a noticeable on a C2 2003 Tiptronic ???
verry goooooood job!!!!!!!
Yea, it took about 2 hours, with out hurrying.
Response is very noticeable, acceleration seem a lot smoother thu the rpms
Just take your time. Not a hard project. Good Luck!
You make it look easy. I hope my install goes as well.