As title this is a quick easy guide to fit an after market radio in to a Partner or Belingo van.
I have tried to quickly cover all aspects of this installation but any questions just ask in the comments below.
I take no responsibility for any harm or damage caused from people using this video guide.
Just need a bit of advice please buddy. There is nothing to connect the orange illumination wire to after installing an aftermarket Sony stereo in my Peugeot Partner Tepee. I want to connect the wire so it dims the stereo lights at night, any ideas would be appreciated. Thanks
Hi mate, I Just need a bit of advice please. There is nothing to connect the orange illumination wire to after installing an aftermarket Sony stereo in my Peugeot Partner Tepee. I want to connect the wire so it dims the stereo lights at night, any ideas would be appreciated. Thanks
Hi thanks , just a quick one, are your stalks working with music n radio? Thanks
Hi so why did you have to add the extra red power cable as its in the harness anyway
Can you tell me how to connect the new wires from new radio to the wires on the old radio the box on the berlingo wires ? Please
What about the service counter lamp. New multimedia resets the service counter km?
Too long…looks hard to do it
Hey, can you tell me what wiring harness I need for a 2007 scudo? Can’t figure out for the life of me, I ordered the CT20FT02 but it doesn’t work? Says it’s for my van though, thanks
The wiring harness I bought for mine doesn't seem to work because of the blue tabs in the vehicles connector block doesn't allow it to connect to the harness adapter,do these need to be removed?
I have a Peugeot 407sw diesel 2L, is the set up the same please?
Good video!