Use as your own risk. seriously. Here’s a handy wiring diagram for 91-94 although it was somewhat useful on my 90.: http://www.bagotronix.com/nissan_240sx_st…
Nissan S13 240SX Stereo Install : How to put in a aftermarket player.
0
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
what size ring terminal did you use?
nice video! i just wanted to know where you connected your radio wire to so
that the antenna goes up and down. I can’t seem to figure it out. Thanks!
Nissan S13 240SX Stereo Install : How to put in a aftermarket player.
nice work.. kinda. lol. i’m actually going over all the wires again
tomorrow with zip ties and more tape just to keep it clean. thanks man.
theres a few spare wires actually. one black from the car side is
pointless, just ground the deck to the screws. and yes both yellow and red
went to the battery, they both are on switched power. g’luck!
stock ain’t so bad these days… if i was still rolling on stock i’d need
cassettes!
Looks complicated.
I miss my old stereo…Now I just roll on stock…LOL!
not really. with a volt meter its easy as pie. too bad i couldnt find mine
:/
I needed a special adapter kit thing to put the system in my truck then
they gave me a deal if I let them install it and run wires for the amp
Looks good…nice work!
running wires for a amp is a good idea. might as well do it while i am
working on it eh?
They charged me $20 for the install, the adapter itself was $80 and $139
for the deck. The amp and subwoofer I already had.
I installed mine. And no power. I notice u connect both yellow n red
together but both them goes to red battery right? Did u connect it with
antenna also? And last question ground. I notice 240sx doesnt have ground
and you have to ground it urself right? Lmk