How to Replace Front Wheel Bearing and Hub 2008-2013 Nissan Rogue

How to Replace Front Wheel Bearing and Hub 2008-2013 Nissan Rogue

Buy Now!
New Wheel Bearing & Hub Assembly from 1AAuto.com https://trq.video/ia-1ASHF00466
New Wheel Bearing & Hub Assembly Set from 1AAuto.com https://trq.video/ib-1ASHS00879

This video shows you how to install a front wheel bearing and hub on your 2008-2013 Nissan Rogue. Not only can a worn wheel bearing or hub be annoying if it is noisy or vibrating, but it can also lead to accelerated wear in other parts, or unsafe driving conditions. Replacing your worn bearing or hub with a quality TRQ part is a safe, smart, decision.

This repair was done on a 2009 Nissan Rogue S 2.5L Sport Utility 4-Door AWD Automatic and the process should be similar on the following vehicles:
2008 Nissan Rogue
2009 Nissan Rogue
2010 Nissan Rogue
2011 Nissan Rogue
2012 Nissan Rogue
2013 Nissan Rogue

Tools you will need:
• 10mm Socket https://trq.video/oa5M-1AXAA00017
• 17mm Socket https://trq.video/obo9-1AXAA00015
• 19mm Socket
• 21mm Socket
• 32mm Socket https://trq.video/och-1AAST00003
• Side Cutters
• Ratchet https://trq.video/obwK-1AXAA00016
• Socket Extensions https://trq.video/obo9-1AXAA00015
• Torque Wrench https://trq.video/oaAy-1AXAA00044
• Brake Grease
• Gloves https://trq.video/oXD-1AXSS00048
• Safety Glasses
• Sandpaper
• Floor Jack https://trq.video/o2j-1AXAA00068
• Hammer
• Wheel Chocks
• Wire Brush https://trq.video/osi-1AXAA00079

Subscribe: https://www.youtube.com/channel/UCWCdsftsTqYMO7cA_5Sc-yA?sub_confirmation=1

Check out our playlist:
Nissan Rogue 2008-13 1st Generation: https://www.youtube.com/playlist?list=PLJVpHWuCEUX8_YYAfxq2hHkD2Ur6xuGXZ

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

43,102
Like
Save


Comments

@TRQ says:

√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

@beboeltio1352 says:

Terrible job I would of call the customer to instal a new shield

@betterwithcoffee8008 says:

2011 Rogue = It is NOT a 32mm nut on the axle. Going back to store now………

Comments are disabled for this post.