In the video, 1A Auto shows how to remove and replace a failed or damaged ABS sensor. The video is applicable to the 06, 07, 08, 09, 10, 11, 12, Nissan Altima.
🔧 List of tools used:
• 10mm Socket http://1aau.to/oFw/1AXAA00017
• 21mm Socket http://1aau.to/okK/1AXAA00043
• Plastic Fastener Remover http://1aau.to/oaa/1AXAA00290
• 1/2 Inch Breaker Bar http://1aau.to/ogK/1AXAA00078
• Socket Extensions http://1aau.to/oKx/1AXAA00015
• Torque Wrench http://1aau.to/ooI/1AXAA00044
• Floor Jack http://1aau.to/om8/1AXAA00068
• Jack Stands http://1aau.to/one/1AXAA00065
For More Info visit us at http://1aau.to/h/bBT/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Visit-1AAuto
√ Do it Yourself
√ Save Money
Why can’t I find a abs wheel speed sensor for my 2016 Nissan Altima on A1 auto
I posted my comment but it’s not showing
So the altima has VCS or w.e its called , my VCS light is on, abs light and some other light someone said it could all be on due to a bad abs sensor
Do you guys have any advice on how to test these wires before replacement?
What if the new sensor doesn't slide in? Put a new hub on, any chance its a non-abs part? Doesnt seem plausible but may be possible.
I don't want to gorilla it in and break it then have to disassemble hub.
How can I know which sensor is the one that is failing?
Is there one or more ABS Senser
Will the same method work for a 2011 Nissan Maxima I having TCS issues. Also need a MAF sensor could be an issue as well.
How would u know which 1 doesn’t work
I have a 2003 Nissan 350z…my front passenger side caliper locks up on its own without applying the brakes and then releases. It only does it after starting my Z and the first few yards of driving. Could a bad ABS sensor cause the brake to lock up then release?
What can I do to remove the sensor if its seized in place? Tried for about 30 minutes, no amount of prying or wiggling would loosen it up.
Are there also rear ABS sensors? Is the process pretty much the same for replacing them?