This video shows you how to replace the front brake pads and rotors on a Mitsubishi Lancer ES
Tools Required
Jack
Jack Stands
Wheel Chuck/Block
Impact Gun/Breaker Bar
1/2 Torque Wrench
1/2 Ratchet
3/8 Ratchet (Optional)
Socket Sizes 17mm & 14mm
Brake Parts Cleaner
Brake Parts Lubricant
Antisieze
Brake Caliper Piston Press/ Large Pliers
Screw Driver
Wire Brush
Bungie Chord
These specs are for the SE/DE/ES GTS Sport Back
Caliper to bracket
28-36 Ft.-LBs
Bracket to Knuckle
67-81 Ft.-Lbs (Front)
39-44 Ft.-Lbs (Rear)
The torque specs for bracket to knuckle say and front and back. What do you mean about front and back?
Forgot to tell us the torque specs for the caliper bud that's the only reason I watched the video waste of time
At 8:25 would this clip be necessary? My old pads didn't have it, so I assumed I didn't need the clip on my new pads.
What does that little clip on the inside pad do?
@revitauto what is the torque spec for the caliper mounting bolt?
Good job bro.
What lbs was the torque ? Great video
What was the torque spec for the caliper bracket?
Is it me or did you not clean off the surfaces of the rotor?
Is it me or did you overtorque that caliper mounting bolt 11:06
The front brake pads replacing on the Mitsubishi Lancer 9 https://www.newkidscar.com/car-repair/the-front-brake-pads-replacing-on-the-mitsubishi-lancer-9/
You destroyed the caliper piston seal.
Revit Auto. Hi, who sells the batteries Ratchet, can you put a link, I will like to buy the same brand that you have. Thanks.