Hi Sterling thanks for the great video. I wasn't sure about taking this maintenance on but after watching your video I think I can do this without much trouble. Your detail is awesome. I have one question though. When bolting the lower end back up with the 3-10mm stainless bolts do you use any anti-seize on the threads? Actually I would like to know if I should be using anti-seize on any stainless bolt going into aluminum? Thank you in advance. Greg
Hi Martin. Watching u from France. I just bought a 9.9 mercury 2strokes, and your video just helped me a lot for my first steps with my new engine. Thanks a lot.
For anyone, I have a 80-81 mercury 4hp with tank on top, there is a knob on left side (looking at front) that opens and close fuel, it is attached to fitting that line from fuel tank goes and another nipple with line to carb, the fitting is plugged with old gas I can’t get the knob off or the fitting out, the part is no longer made any suggestions appreciated
Thank you very much, Mr. Martin. I had the bright ideal a year ago to replace my water pump, I taken it apart ! and now what's next , well as Don Buck said thanks for a well prepared video . Do you carry the water pump kit?
Do you know what the part number would be for the oil seal on the drive shaft under the water pump? I think that is where I am getting water in my lower unit.
){kind=link}
Hi Sterling thanks for the great video. I wasn't sure about taking this maintenance on but after watching your video I think I can do this without much trouble. Your detail is awesome. I have one question though. When bolting the lower end back up with the 3-10mm stainless bolts do you use any anti-seize on the threads? Actually I would like to know if I should be using anti-seize on any stainless bolt going into aluminum? Thank you in advance. Greg
Any way you help me get main bearings and rings
Hi Martin.
Watching u from France. I just bought a 9.9 mercury 2strokes, and your video just helped me a lot for my first steps with my new engine. Thanks a lot.
Great video! Would the 5hp 2-stroke Mercury be different and different kit (guessing same vintage as the one in the video)?
Awesome detailed video. I subscribed. Keep doing what and how you do it… Subs will grow… From south Africa
Do you have a video showing how to do the prop seals too?
For anyone, I have a 80-81 mercury 4hp with tank on top, there is a knob on left side (looking at front) that opens and close fuel, it is attached to fitting that line from fuel tank goes and another nipple with line to carb, the fitting is plugged with old gas I can’t get the knob off or the fitting out, the part is no longer made any suggestions appreciated
Thanks from Italy i have this motor and i happy it!!
What kind of grease ya using?
my shift rod isn’t seating right and when i took it out the engine was in gear… any suggestions(my problem is seating the shift rod 12:30 in the vid)
Thank you very much, Mr. Martin. I had the bright ideal a year ago to replace my water pump, I taken it apart ! and now what's next , well as Don Buck said thanks for a well prepared video . Do you carry the water pump kit?
Do you know what the part number would be for the oil seal on the drive shaft under the water pump? I think that is where I am getting water in my lower unit.
Thanks for a well prepared video. One of the best tutorial on replacing a water pump I've viewed.
thanks a lot from Rosario, Argentina. Your really help me!
do you sell these kits