http://www.curtmfg.com
This video depicts the installation of the CURT 13186 Class 3 trailer hitch on a 2016 Mazda CX-5.
Install Sheet –
https://www.curtmfg.com/masterlibrary/13127/installsheet/CM_13127_INS.PDF
Application Coverage Information:
http://www.curtmfg.com/page/application_guides
Special Notes:
***DO NOT EXCEED VEHICLE MANUFACTURER’S RECOMMENDED TOWING CAPACITY***
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Warning:
-This video is intended to be used as reference. Please refer to print instructions for complete installation information.
-Need help or have some questions? Call Technical Support at 800.798.0813 (Monday-Friday 8am-7pm CST)
… Bummer, bought the drawtite version. Hopefully their open-ended cross tube doesn't promote (extreme) corrosion. Looks like the curt is superior in this way as the cross tube is closed off on the sides
Best explanation out of all other hitch companies. I've watched other one's and this one is by far the easiest to understand.
Thankful for video but have to state this took over an hour on '17 model. I don't have a lift, and needed help holding/jockeying the hitch in place. Taping the washers was also a pain as any movement to fit would loosen so mind that. I would thread the forward most bolts then swing up the hitch to feed the wired bolts in last. If doing on a garage floor, I would suggest jacking rear up, then add strap to hold the exhaust pipe, but know the muffler has to drop a foot for sides of hitch to clear the muffler pegs, that would catch. Also, not everyone has access to that dampner puller-I sprayed some silicone on the pegs and they came off with prying/elbow grease. Again, helpful video but can take an hour or more and make sure you have buddy to help lift hitch why your thread the bolts.
Where cannI buy that ray gun?
I have 2016 cx5, uhaul only had class 1 hitch in stock, how much will a class 1 tow and is that strong enough for a trailer plus load
Confused. The 2016 CX-5 can support tow capacity of class 3 hitch or is this just overkill?
Great video, was a total help in seeing how to thread those bolts through easily as a novice. Thanks!
Similar process for the 2014+ maxda 3 hatch? Great video and even better work guys!
Will the exhaust rattle against this hitch?
Thank you so much for the great videos, very well done. I'm legitimately impressed, keep up the great work.