Replace the brake pads and rotors yourself, on a Mazda CX-30. It’s easy when you follow the step by step details outlined in this video.
0:00 Introduction
0:24 Remove: Brake Caliper & Brake Pads
1:25 Remove: Caliper Bracket & Brake Rotor
2:26 Install New Brake Rotor
3:41 Install Caliper Bracket & Brake Pads
7:11 Lubricate Caliper Guide Pins
8:41 Reset Caliper Piston
10:41 Install Brake Caliper
#automobile #diy #howto #brakerepair #replacebrakes #brakerotors #brakepads #mechanic #savemoney
){kind=link}
Thank you for the videos. They are concise and easy to follow. I've done lots of brakes in the past , and your videos are a real good refresher.
Is the Loctite necessary?
Thank you for the detailed video
Awesome thanks
Thanks for the detailed video. I used it for the Mazda 3 and was right on up until compressing the piston. Big debate on whether press or turn. The video shows compression but turning while pressing with tool worked for me. Otherwise very useful
Don't hammer the rotor off. There's a 6mm threaded hole between 2 of the studs. Thread a bolt into the hole. Keep tightening an it will free the rotor from the hub.
Very nice work
I really appreciate your time and help
Just did mine today took me 15 min each thank you !
I think you're supposed to use the blue loctite, not the red one. Red is permanent.
Thank you for the detailed video. Cheers!
Where did you get the torque spec. I have to do rear brake pad and can not find the torque for my CX30
At 3:45 you say to compare the old and the new hardware to make sure their the same. But you didn’t check the second one and it’s different then what you have