After painstakingly fitting and spot welding each and every single weld that was drilled out. They were grinded and smoothed with “Evercoat OEM Metal Glaze” and the seams were sealed with Evercoat…
After painstakingly fitting and spot welding each and every single weld that was drilled out. They were grinded and smoothed with “Evercoat OEM Metal Glaze” and the seams were sealed with Evercoat…
You must be logged in to post a comment.
yes dont do a cheap ass can job!!!!!!
@Dadshouse159 Well being I am not near your car I can only offer this
advice, Watch some videos and buy some books or take a body and welding
class first. Do you have experience with a torch TIG or MIg welder? Get
some spot weld drills and go at it! Only way to learn is to do it. =D
I have an rx7 I need to replace the quarter panel on the other side any
tips for me?