How to Replace Rear Brake Pads and Rotors on a 2008 Lexus IS250

How to Replace Rear Brake Pads and Rotors on a 2008 Lexus IS250

Brian Eslick from How to Automotive http://www.howtoautomotive.com takes you step-by-step through the process of replacing the rear brake pads and rotors on a 2008 Lexus IS250.

Affiliate link mentioned in the video for Brake Pads http://amzn.to/2gpPSAO

Affiliate link mentioned in the video for Brake Rotors http://amzn.to/2g0m4KL

Website
For more videos, tips, and to purchase recommended tools and products visit my website at: http://www.howtoautomotive.com/

Stay connected at:
Email: howtoautomotive@gmail.com
Facebook: https://www.facebook.com/How-to-Automotive-432536836946801/?ref=settings
Google+: https://plus.google.com/+HowtoAutomotive/posts
LinkedIn: https://www.linkedin.com/in/brian-eslick-819839118

Disclaimer
Owing to factors beyond the control of How to Automotive/Brian Eslick, it cannot guarantee against unauthorized modification of this information, or improper use of this information. How to Automotive/Brian Eslick assumes no liability for property damage or injury incurred as a result of any information contained in this video. How to Automotive/Brian Eslick recommends safe practice when working with power tools, automotive lifts, lifting tools, jacks and jack stands, electrical equipment, blunt instruments, chemical lubricants, or any other tools or equipment seen or implied in this video. Because of factors beyond the control of How to Automotive/Brian Eslick, no information contained in this video shall express or imply warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or information contained in this video is the sole responsibility of the user and not How to Automotive/Brain Eslick. #howtoautomotive

11,386
Like
Save


Comments

Jose Leon says:

I replaced the pads and rotors on my 2010 is250 and over 20mph it sounds like a bicycle chain when ever I step on the brakes, the rears, seems like the hardware kit they came with aren't stiff enough and the 2 bolts are just rattling when I hit the brakes no matter how much pressure…. any input?

Don Bain says:

Thanks very helpful

Hamyar says:

Great video, If you are not replacing the rotor and only replacing the pads, do you still need to remove the caliper ?

rcmodder64 says:

thanks my friend,you saved me a few £££££££s.nice video

Write a comment