How to repair Land Rover spring plates.
Land Rover Repair Guide No.1
12
Like
Save
){kind=link}
Comments
Write a comment
You must be logged in to post a comment.
How to repair Land Rover spring plates.
You must be logged in to post a comment.
I’m no Rambling Hiker. But shouldnt your jeep be a bit quieter?
ALSO, and probably easiest — Use 3 12 volt auto batteries wired in series, negative to positive, using 2 short wires and a jumper cable as an arc welder for 3/32 stick, using the pos. side of the circuit as ground which makes a stronger arc. Ordinary arc eye-protection required, #10 filter lens. This will make a surprisingly effective & durable weld-repair.
Hmmkm … I would have used epoxy or superglue, and THEN wrapped well with duct-tape. After all, it IS a key suspension part. Even better, rewire the shop’s main service buss for the buzz-box. OR modify the vehicle’s existing generator as a welder. Alternatively, make a forge to use charcoal, melt some scrap steel and hammer-weld repair the part, making it twice as thick. Or cannibalize the mount off one of the rolling-stock parts cars.
why don’t you try chewing gum? will much better hold than tape :-)
not enough tape. i dont think it will hold.