How to properly replace a blower motor in an LR3 in 15 minutes.
Land Rover LR3 Blower Motor Replacement
65,836
Like
Save
){kind=link}
- Tags:
Blower, Land, motor, Replacement, Rover
- Categories: Land Rover
Comments
Comments are disabled for this post.
It would have been much more useful if you actually filmed from the start when, where and how you took off the panels first anyway apart from that a great informative and helpful video. Would this procedure be the exact same on a Landrover discovery 4 2011 car because when I turn on the blower I only get high speed so therefore I think it is the blower motor resistor.
Do you know if this is the same for a Range Rover Evoque?
Nice Video, very helpful. It stops at 1:55, I get the impression there should be more..
Thanks so much….saved me a couple….
I had the same issue, seems that when you hit the blower or slap it, It will work again. but will inspect it soon, And might replace it if needed.
Great video – worked for me and saved a pile of money. Thank you!
Just SAVED me , I thought I would have to tear the dashboard apart, Thanks!
Anyone looking for the motor or resistor look to Rockauto.com it has the best selection & good prices.
My front a/c is not blowing any air. Only the rear. is it blower motor or blower motor resistor? Thanks in Advance
This video was extremely helpful. Thank you for taking the time to film it.
Thank you for the video. It was really easy . I also replaced the resistor since it was right there. 🙂
do you know where the servo's are located?? I have cold air blowing on drivers side so I believe my servo is gone bad.
Where did you get a new blower and how much was it Please.
Thanks