the instructions say to ratchet strap the rear axle to the fron trailing arm mount bracket. that would be severely in the way. Am I reading this right? Also doesnt look like it was done in this video.
After undercoating, at 6:32 I see only spot welds on the underside over the whole length of the panels….is this correct? Will the frame strength be better than factory or similar?
What weld setup do u think is ideal for this? would a 110 flux handle this running no gas or gas is necessary. I believe I saw it was cold rolled 11 ga correct
Can you guys do a segment on the prep and welding process on the inboard portion of the frame? Do you guys remove anything besides the control arms? I’m in the middle of my repair and had to remove my muffler due to workspace. What tips in this area can you recommend?
Any questions call me 401 368 6211..glad to talk and help! Jerry
Awesome product. Made in the USA. Thanks for letting me tour the shop. You guys saved my Jeep. Thank you.
This is my company and am so proud of the great work done by my associates! I am 76 and still working and love it..but it's not work!
you guys only repair "things that hold in value"
They would move to one side and be careful!
What do you with fuel and brake lines when cutting old frame out
the instructions say to ratchet strap the rear axle to the fron trailing arm mount bracket. that would be severely in the way. Am I reading this right? Also doesnt look like it was done in this video.
Go to POCONO METAL CRAFT, thicker steel, half the price
Your video is your brand. The work was excellent and the filmwork showed it.
how much does this cost,, snd where are u located
do you have a kit for 2000 4runner?
Is there a shop in Virginia Norfolk area?
I am dealing with the exact problem how much that cost? and how can I contact you guys
After undercoating, at 6:32 I see only spot welds on the underside over the whole length of the panels….is this correct? Will the frame strength be better than factory or similar?
What weld setup do u think is ideal for this? would a 110 flux handle this running no gas or gas is necessary. I believe I saw it was cold rolled 11 ga correct
Do they make anything like this for squarebody
That’s anyone know who installs these repair kits in the Orlando/ Daytona Beach area?
This is amazing.
where can we get that undercoat yall have there
Anyone in ct. Do this?
I like this kit better than any of the others ive seen
Is there any way to coat the inside of the frame without cooking it off while welding?
Can you guys do a segment on the prep and welding process on the inboard portion of the frame? Do you guys remove anything besides the control arms? I’m in the middle of my repair and had to remove my muffler due to workspace. What tips in this area can you recommend?
Couple of days.
How long does the process take from getting in to completion, typically?
Great video guys!
Can you give me a name of somewhere in Ohio near Columbus that can do the same thing you guys are doing with your product thank you
What dose it cost to do a full sand blast
What would it cost to install the 132 part?