Today, Jake the pretend mechanic installs a gas cap cover on a Jeep Wrangler Unlimited JK. This gas cap cover will also fit Jeep Wrangler JK 2-Door models as well. BUY THIS GAS CAP COVER HERE; https://amzn.to/2TfhPfi
Today, Jake the pretend mechanic installs a gas cap cover on a Jeep Wrangler Unlimited JK. This gas cap cover will also fit Jeep Wrangler JK 2-Door models as well. BUY THIS GAS CAP COVER HERE; https://amzn.to/2TfhPfi
Comments are disabled for this post.
I’m actually looking for the trim ring cover that you removed! Where can I find that? Is it a stock wrangler part?
I bought one from Amazon this past week. They had a returned red one for $2.22. Doesn’t match my red paint so I Sprayed it with black bed liner. Can’t believe I got it so cheap. No cracks or dents.
Lol rubbing alcohol does not dry out rubber it actually softens it and the higher percentage evaporates so you don’t have to worry about it staying on the silicone
They have locking ones now with the gasket included.
if you mess up the o-ring it will put on the engine light its so annoying
What a mess…this guy was painful to watch
Why didn’t u get the one that locks with the key?
I’ve seen the other kind of gas door but it’s just the outside part and doesn’t have the inside part .
Do you have a left on your truck?
Great video, was much better than the paper instructions that came with it. No tabs or anyhting on my new cover and 4 really tough tabs on the original. Also my replacement cover came with a new gasket.
Very helpful video! Convinced me to buy one! Worth it for just 30min of labor
Thanks! Definitely helped.
Biggest problem was the o-ring, had trouble getting my gas cap to lock. Thanks for the tip about the pins!
Thanks man, be careful when you install these, of you get the gasket to not sit right and you'll get a check engine light. It's the evaporation s leak sensor, but it scared the hell out of me at first.
silcon spray on the rubber seal works great to slid it over the gas spout
Very nice! I appreciate your humor, it kept me entertained through out the video.
15mn after watching your video, geat job but take care about the 2 top and bottom screws if you dedide (like me)to remove the cover before installing, my scew fall inside the body and very hard to reach it, screw the 2 first before installing the cover
Tried installing the ring after it's too hard this process is so much easier and faster thanks man for the video
Best of the gas cover install videos!!
Good job. Looks good. Thanks
Where is the link
Mine doesn't have a pin. Will that be a problem? Will it rotate, or will clips keep it in place?
Is water able to leak behind the cover and the body where there is no seal?
WD40 does wonders for snapping the gas cap connector on.