jeep grand cherokee ABS REPAIR (ABS MODULE)

jeep grand cherokee ABS REPAIR (ABS MODULE)

READ INSTRUCTIONS FIRST PLEASE !!!!!!!

always take care in what you do , and make sure you know what you are doing whenever working on your cars brake system . read more below …….(BEFORE you start repairing )

this is only here to save you from paying huge bills for parts you do not need and wich can easily be repaired with litlle or no cost .
DO NOT TRY TO REPAIR YOU MODULE UNLESS YOU FULLY UNDERSTAND WHAT YOU ARE DOING !!!!

ALL AT YOUR OWN RISK !!!! (it isn’t really that hard )

this is a little vid wich shows you how to repair the ATE abs module .
it’s a simple repair which can be done without bleeding brakes or anything .

first you should remove the module from your car .
the module is bolted to the underside of the pump unit with 4 E5 little screws .
i used a small 4mm hex socket to remove this 4 screws .

the next step is to get the module open .
it might look easy with the clips on the side of the module , but they glued it together so you have to saw it open .
i used a litlle hacksaw , and sawd carefully along the edge of the cover .
you have to start sawing slightly higher than the steel bushings .
DON’T go to deep !!!! you’ll damage everything !

when you are so lucky to get it open , go to the corner i point out in the video .
this is the corner where the pump connector is .

the problem is the positive pump terminal .
you should remove the silicone layer very carefull.
don’t make any scratches or damage any component .

after you succesfully removed the silicone layer , you should clean the board a litlle to make sure your new solder properly connects to the board.

after you did this you can seal the module back together (or carefuly test it first )
i used ordinary household silicone to glue it shut .

this repair goes for all jeep grand cherokee vehicles from years 1995/6/7/8 with an ATE abs module .

the module number is 56027931
there are lots more modules with this problem but i don’t know mumbers of that ones (post them in the comments please )

this also goes for jaquar cars volvos bmw and other cars and traction control systems on volvo !
you might wanna inspect al other solder points as well !

please comment if this worked for you .
feel free to ask any question about this repair.

no one can take any rights from this vid or sue me for anything .

195,411
Like
Save


Comments

Chris AZ says:

Question: which pin of the 2-pin ABS motor plug is the +12V side and which is Ground? (e.g. is the outside pin at edge of board pos or neg?). I want to test the motor (it ohms out to about 11.5ohms which seems high) but I don't want to apply reverse polarity, and both motor wires are black. RE: "…go to the corner i point out in the video. This is the corner where the pump connector is. The problem is the positive pump terminal " THANK YOU!

Lambor_ghini says:

nice you fix this by scraping components with a flat blade??

Martijn says:

Some reactions get removed ,i do not tolerate any advertisement or linking in our comments section.
This is just here to help for those who want to fix their own things ,not for companies to make more money .
I am sorry for the inconvenience and hope for your understanding.

john argue says:

No sound. I see u open case and touch everything. Anyways

nowr2run says:

NO SOUND SO ? Please redo this vid. or explain what you did ? THANKS, Nowr2run.

AutocompTaller 10-06 says:

si estas en venezuela, en Autocomp 10-06 te podemos reparar el modulo de cualquier modelo de JEEP, contactanos 04241276869 04123140365 02129851409 estamos ubicados en el centro comercial plaza las americas priera etapa de el estacionamiento, nivel mezzanina local 57-A

G2 CARROS says:

Olá

Percebí que tu curte automóveis. Como possuo um canal onde eu pessoalmente desenvolvo e gravo, daqui dos Estados Unidos, testes de 0 – 100 Km, test-drive e verificações de veículos como por exemplo o mais novo Dodge Charger, o Jeep Grand Cherokee Diesel o recentemente redesenhado Ford Edge, achei que podia te convidar para dar a sua opinião sobre uns dos meus testes.

Por favor, visite o meu canal no YouTube e escreva a sua opinião através de um comentário para que eu melhore a qualidade dos vídeos.

O G2 Carros (G2C) agradece!

Zachary Thurmond says:

Where is this located on a 2000 grand cherokee?

r3830 says:

Thankyou for your video. My Jeep ABS module has a second life.

Maboucha Fakih says:

pls I get jeep compass limited the ABS and the esp and the BAS are on pls can you help me to do my car

claude le lay says:

traduireen francais

Tommy Vercetti | Bad Time Garage says:

hi, vid seems good, but i can't hear the audio…
am i the only one?
pleas respond

bill deal says:

EXCELLENT and compliment you for mentioning that they are glued! I'm not working on the exact same module but similar and I must be pretty stubborn. I would have maybe kept trying till I broke the unit. Good explanation form throughout. Thank You!

John Millett says:

Thanks for your reply.

Lewismaby Lewismaby says:

i mean a macanic

Lewismaby Lewismaby says:

dose the dodge have to be reset by dodge 

Comments are disabled for this post.