An overview of the process to replace the water pump on a Jaguar X-Type.
Parts Installed:
– ACDELCO 252467 (252-467) Water Pump
– BANDO MFG. 3PK590 Belt
Torque Settings:
– Water Pump – 10 Nm.
– Water Pump Pully – 11 Nm.
An overview of the process to replace the water pump on a Jaguar X-Type.
Parts Installed:
– ACDELCO 252467 (252-467) Water Pump
– BANDO MFG. 3PK590 Belt
Torque Settings:
– Water Pump – 10 Nm.
– Water Pump Pully – 11 Nm.
Comments are disabled for this post.
Similar issue on my 2003 X type with the 2.5. Only has 54,500 miles. Going through about a gallon of coolant almost every 2 weeks. I have traced drips right under the radiator under the Jag. Have not checked thermostat housing or thermostat.
Is there a separate housing that goes with the water pump?
Hello, I have a bad leak on my 2006 type s he replaced the water pump and I wanted to drive it, let it warm up first and pulled it out of the shop at idle speed and it beeped the whole time. I parked out front he came out and said it was also running hot. My fans stayed on for a few min after turning the car off. We're thinking it could be a hose now ?? Plzzzz help $$$$
Would you happen to know the part number of the tension pulley?
Thank you it was very helpful I just bought a 2006 x type and the water pump was on of my issue your video was very helpful thank you
It’s a joy to watch the steps. Did u install the serpentine belt? I know it’s a wrestle when I did mine during replacing the alternator.
That is a very well done and informative video. Thank you very much.
Thank you sir
Great video thank you found it very useful I thought it was going to be a lot harder I will now change mind no need for trip to the mechanics keep up with the videos much appreciated
It seems mine is leaking from somewhere behind the water pump. Is there a separate housing of some sort that the water pump is attatched to..?
THANKS FOR THE HELPFULL VIDEO. I HAVE THE SAME PROBLEM IN MY 2.5 PETROL X-TYPE. IS THIS PROBLEM GIVING YOU ALSO A SMELLING LIKE SOMETHINK IS BURNING? THANKS A LOT.
I think you should have used a thin layer of silicone on both sides of the gasket
What engine 2.5 or 3.0?
Thanks mate very informative and helpful.
i have a noise coming from that side of the motor ….not sure if its the water pump or that bearing next to it that has that bigger pulley
no silicone ?
mines leaks coolant from somewhere, not pipes or radiator
lifesaver, bout to replace water pump too.