Injen Cold Air Intake Installed by Females on a 2008 Infiniti G35S Sisters, Angel and Riki install an Injen Cold Air intake on their 2008 Infiniti G35S Sedan…
Injen Cold Air Intake Installed by Females on a 2008 Infiniti G35S Sisters, Angel and Riki install an Injen Cold Air intake on their 2008 Infiniti G35S Sedan…
You must be logged in to post a comment.
){kind=link}
This would have been good if that whore wasnt singing her music in the backround.
Loving to see women who know how to work on vehicles! Great Job and Hella SeXy!!! Keep up the Good Work!
I have the strangest boner right now.
Hey, would I get the same, (or comparable) results with the installation of a short ram instead of a full length cold-air intake?
A little enthusiasm wouldn’t hurt much as well as a before and after. So we can get a good sound comparison.
too bad NWP doesnt make the 75mm TB’s for the HR yet
VQ’s are notorious for heat soak… hence the clutch fluid problems…. well worth the great performance though
cold air intakes actually make upward of 15-20whp on the HR motor…. nice troll attempt though
gen 3 is the best available.. of course uprev dyno tune is recommended with any intake mod on these engines
good little whores but they should just stick to s and f some guys
nice work. shitty songs
so sexy watching a woman driving manual 🙂
Can I install my D to your P?
Sexy as hell… oh and the girls too… lol
nice…lose some power but gain an induction noise….
your 2007 g35 uses the same intake that the 2003-2006 350z uses, and by that I mean its the single tube not dual intake like this. at least from what I’ve seen.
Can i have the exact name and model of that air intake?…..it just because i have the same car but mine is a Nissan Skyline V36 2007
Gettin an intake kit this week, would this kit be recommended over Stillen Gen 3?
ok ok guys calm down we all know uve never been laid before
lol
LOL
that aint the kinda box I was hoping to see
LOL total waste of money, the stock boxes with venturi rings do a better job than a “CAI” without air bypass valves.You should have spent the money on a plenum spacer and res-cats. That mess is one deep puddle away from hydrolock.
nice job ladies
I’d leave it stock. Too much work lol.
Enough with the sandwich jokes, theres laundry that needs to be done.