Today we are going to install new Brakes and Rotors on the front end of my 2009 Infiniti G37. The process is fairly simple really. Just jack the car, remove the wheel, remove the caliper (four screws), then remove the rotor. Let me know your comments on this in the section below.
){kind=link}
Looking at the field service manual, the bolt with the flats on it goes in the 'bottom' position (trailing edge). Apparently it "helps" reduce noise as well as proper sliding action. You could wear the pads out quicker if it's in the wrong position. I may not take things apart just to check that but maybe next time you rotate the tires you could check it.
Good video on the front and rears! I'll be doing my rears this weekend, and saving money too, thank you!
Very well make video – thank you for putting this together!
I had the same problem with my g37 sedan until I bought frozen rotors . Twice as expensive but well worth it.
My brake pads didn't come with clips. Can I use the old ones?
Great Video!
Fantastic video. Thanks Dan!
Cool video, thanks, you should get a large C clamp like I have. Forget the screwdriver, use the clamp and it's done in seconds I also just use the old brake pad instead of a wood block. When I remove the caliper I pull the outer pad stick the C clamp on the old one and push it back then remove the old one and it's ready to go.