Buy Now!
New Starter from 1AAuto.com https://trq.video/ia-1AEST00522
This video shows you how to install a new starter from TRQ on your 2011-2014 Hyundai Sonata (2.4L L4). The starter is a powerful electric motor that gets your engine to turn over when you turn the key in the ignition switch. If a motor has worn out or become damaged, your vehicle won’t start.
This repair was done on a 2013 Hyundai Sonata GLS 2.4L Sedan 4-Door FWD Automatic and the process should be similar on the following vehicles:
2011 Hyundai Sonata
2012 Hyundai Sonata
2013 Hyundai Sonata
2014 Hyundai Sonata
Tools you will need:
• 13mm Wrench https://trq.video/o9d-1AXAA00010
• 10mm Socket https://trq.video/oby6-1AXAA00017
• 12mm Socket https://trq.video/obVV-1AXAA00015
• 14mm Socket https://trq.video/obVV-1AXAA00015
• Ramps
• Trim Tool Set https://trq.video/oarv-1AXXX00006
• Pliers
• 3/8 Inch Drive Ratchet https://trq.video/obVV-1AXAA00015
• Socket Extensions https://trq.video/obVV-1AXAA00015
• Swivel
• Torque Wrench https://trq.video/oa3t-1AXAA00044
• Brake Parts Cleaner
• Cloth Rags https://trq.video/oKV-1AXSS00035
• Gloves https://trq.video/oaNF-1AXSS00048
• Safety Glasses
• Magnet – Extendable
• Razor Blade / Gasket Scraper
Subscribe: https://www.youtube.com/channel/UCWCdsftsTqYMO7cA_5Sc-yA?sub_confirmation=1
Check out our playlist:
Hyundai Sonata 2011-14 6th Gen: https://www.youtube.com/playlist?list=PLJVpHWuCEUX_4iB_GgpdTsu8hzlflb_DH
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
){kind=link}
√ Watch the Video
√ Buy The Part at 1A Auto http://1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money
Really bad advice. He should have said in the beginning that you need to have access from above and under the car!
That vid is AWFUL
Many of these steps are unnecessary, and just make the job more difficult. Remove all parts up top, as described, DO NOT touch anything underneath car. Leave the shielding, leave the bracket. Undo the 2 mounting bolts, unclip zip-tie retainer on starter cable harness, starter can now be turned, so you can easily reach cable and solenoid wire. Turns an hour job into ten minutes.
replaced the starter on my 2013 Sonata over this weekend. Very helpful video. in my car, the electricals on the starter were not at all visible so I had to take the starter off before.
Hyundai says remove the intake also, I just saw this done, from the top ,nothing from the bottom took about 15 minutes to get it out
Or just take the starter out from the bottom, in 1/3 the time
Wtf all this to replace the starter?
Is this the same removal for a azera of the same year?
Followed your video exactly and it came out perfect. Exactly what he said to remove.You have to do it to do this job right and it went along very well.Thank you so much.Saved me a ton of time time
Keith
I've installed 4 of these in the past. I didn't take anything loose up top except the negative battery cable.
What was the point of removing everything up top if you were just going to install it from the bottom
Unlike in most of your videos, here you did not provide a clear prospective like where exactly the starter is located. Also when removing the nuts of the starter and putting them back I have no idea if you were doing it from under the car or from the top. All the the time the camera was too close to the nuts and bolts.