Follow me – Subscribe
https://www.instagram.com/g2gbuilds
http://www.youtube.com/g2gbuilds
http://www.facebook.com/g2gbuilds
DISCLAIMER: I’m not responsible for any damage you do to your vehicle. This video has information I couldn’t find when I did it, so I want to help someone out there in the same situation.
In todays video, I successfully installed a new oem clutch into my 1999 Hyundai Tiburon FX RD! This process will be very close to some Hyundai Elantra since they use the same clutch. I hope this video helps someone in need. Thanks for watching!!
Thanks for watching and God Bless!!
Thankyou for dumbing it down
Great video.
My daughter is using it on her 2000 Tiburon.
We got the motor and tranny separated, past the pins,…then that's it.
Starting fresh here in a couple hours.
Any hints? Brute strength perhaps?
hey man you helped alot but i can't get my trans past the subframe anything you could recommend for me it would be extremely appreciated
G2G and GJ (good job)
can I follow these same steps for a v6? and how long did it take you?
You can hit me up bro anytime on instagram if you have any question on the rd's
That's not the drain bolt bro its on the bottom has a magnet on it think 23mm. how you remove the transmission with the fork still bolted to the the lever that goes to the slave ? had to be a pain. you should remove the lever and it lets the fork swing free. also with linkage much easier to just un bolt the two 12mm that holds it to the bracket. just a few tips in case you need to do it again in the future
Shocks are leaking