2021 – 2022 + Hyundai Tucson Amp and Sub Install

2021 – 2022 + Hyundai Tucson Amp and Sub Install

Parts used linked in the description below!

Watch a full tutorial as a 2022 Hyundai Tucson Hybrid will have a new SSL 10″ powered subwoofer installed under the passenger front seat. This amp and sub combo will add between 100 – 200 watts RMS of bass to the factory sound system. Note, this Tucson was not equipped with the factory Bose sound system.

This video applies to Hyundai Tucson models for years 2021, 2022, and newer. This video also includes complete amplifier wiring, installation, and testing.

If you have any questions, leave a comment below! Be sure to like and subscribe!

Parts used in this install (Amazon Associate Paid Links):
*Sound Storm Labs (SSL) 10″ Powered Sub: https://amzn.to/3HqIEWP
*8 Gauge Amplifier Wiring Kit: https://amzn.to/3iWX7jK

*Disclosure: As an Amazon Associate I earn from qualifying purchases*

3,960
Like
Save


Comments

Provo Beast Audio Installation says:

Parts used linked in the description of the video!

Stuart Evans says:

How do we even know it worked?….

Richard Duvall says:

@11:42 I have 2 green wires and 1 red wire. Did you use the green wire that's at the bottom with the red wire or use the one at the top of the connector? Thanks! I have a hybrid SEL convenience if it matters.

Robie Johnson says:

Would this void a car warranty

Saurabh Prasad says:

Thanks for posting this detailed video. Much needed.

mike barcus says:

Have you done one with the bose system? I have it and the 9 inch sub is lacking. I was hoping to either swap it for a new sub or add a sub.

Matthew Roberts says:

Hello, did this vehicle have seat warmers? I am curious as to in if the sub would fit with seat warmers? Thanks!

Clint Chron says:

Seems that you are losing half of your base signal by not tapping into both the left and right speaker channels.

Tren D says:

12v is in the rear of the car so much easier to run wires.

Unboxing Bastard says:

I purchased a 22 Santa fe, do you know if the color code is the same? Also I was going to tap both sides ( Driver side and pass. side). Do you know where I can look up the color codses? Thanks!

Louise Herold says:

sound test plz

schwolmart says:

Good stuff. I'm a novice and have a basic system in my 2016 Tucson. Alpine R front/rear on a Kenwood XR401-4 and a 12" R-Series in their prefab ported box on a SoundQubed S1-1250. How would a novice find out how to access the hatch of this vehicle to try and start sound treating? My sound sucks and I think that would help tons.

To edit. I should just post this to reddit or a forum but anyway. I'm gonna wanna have a bunch of spare clips and whatnot cause I assume I'm gonna pop all that. Just looking for any thoughts.

Comments are disabled for this post.