My 2007 hummer H3 air conditioning stop blowing air. Found out the problem was the blower motor resistor had a faulty wire harness connector that burns out. …
My 2007 hummer H3 air conditioning stop blowing air. Found out the problem was the blower motor resistor had a faulty wire harness connector that burns out. …
You must be logged in to post a comment.
When I made this video I was thinking this would “FIX” the problem…. but now a year later it seems it is going out again. It seems that this is only a temporary fix. It Should Be A RECALL !!!!!
we are replacing our 3rd one!!!! today. my 2006 has 162k miles.
where do I find a replacement wiring harness for this 2007 motor resistor? Help
THANKS SO Much , This was the problem for sure , went to the local GM dealer and in 30 minutes it was done and fixed , Saved so much money here. Hail You Tube!!
GM PARTS DIRECT.COM…go to catalog….put in your year make etc…go to body hardware…then to interior…and find your part….that’s it…hope that helps…Sammy
Does anybody know where I can find a black/ grey center armrest/console lid for my ’08 h3 alpha? Mine is cracked badly and uncomfortable to rest my arm on. I can’t find any on the Internet anywhere! Would appreciate any help
This video made my day, I tought it was gonna b hard to figure out how to fix it.thanks so much.hoooray
If you have not found it yet the part # is ACDelco 15-80647. You can find it on Amazon for 17 bucks.
I been looking everywhere and cant find it i already order the resistor
Where can i get the connector
Mine broke last week, the day b4 it started snowing like crazy, I ordered my resistor and harness from Amazon for $25.00, I can’t wait till it finally geys here so I can guys it already…
Nice mine just stopped working in my 08 h3 I’ll have to go check this out
thank you for the video, , I discovered a quick cheap fix, bought new resistor at advanced auto for $25.99 , also used one male terminal, I just cut away the burnt channel and cut off the burnt terminal, then put the new terminal end on the 1 bad wire.The area i cut off the rest of the connector freed up enough room to all fit together nicely ! No need to buy new harness, or relay , I’m up and running for about $27 including tax. again thanks for the video. Running like new ! Thanks for the help
I have already replaced my resistor twice, and this time I have to replace the harness. I have submitted my findings to the NHTSA because this should be a recall from GM. Your plug and harness are burned up the same as mostly everyone who experiences this failure. Why should WE as consumers have to wait until there is a fire before someone steps in?