How To : Replace Honda Civic Si Door Lock Actuator

This video is a simple how to guide on replacing a faulty door lock actuator on the 2002 – 2005 Honda Civic Si. This video shows replacing the driver’s side,…

Comments

5133937C311 says:

January 3, 2014 at 9:45 pm

I bookmarked your video because I’m about to do mine on the passenger side
as soon as I get my actuator in. Excellent walk through on the procedure.
Even though I have just an LX I got the idea of what to do.

Patti Medina says:

January 3, 2014 at 10:16 pm

yes your showing how to change it. But your car door is open, my is not.

Joseph Matthews says:

January 3, 2014 at 10:42 pm

Thanks for this video. Really helpful!

oregonskate says:

January 3, 2014 at 10:56 pm

So on my si the driver door won’t unlock manually in fact the key wont even
go in but only half way, my passenger side is starting to do this, do I
need to replace what you did in this video? @greengook

spike378 says:

January 3, 2014 at 11:12 pm

Just finished mine and its working! Some tips. When you pull the door panel
out, on the handle side there is actually a piece of plastic you will need
to slide out instead pulling. For the lock assembly screw, do not use
ordinary phillips screw driver. I almost stripped mine but fortunately I
hate a phllips bit that fitted “Perfectly” along with the socket wrench I
used. My impact doesnt have this adapter. And for the last part where you
have to yank it out there is actually no pin or anything

he lvis says:

January 3, 2014 at 11:38 pm

You roll the window up before you start.

Adam Alsnayyan says:

January 3, 2014 at 11:58 pm

He called my hands fat 🙁

twistymcslide2 says:

January 4, 2014 at 12:29 am

sounds like you were in the military from your directions. thank you for
your service. if im wrong, than thanks for the directions. doing my pilot
ths week, hope its close, didnt pull door off yet . good call on the thread
lock and suggestion to test before re assembly . often overlooked, and
regretted.

000CLos says:

January 4, 2014 at 12:42 am

same goes to 72155-SDA-A01? …im assuming.

timebomb12 says:

January 4, 2014 at 12:49 am

thanks for doing this video…very very helpful.

conceptjdm says:

January 4, 2014 at 12:59 am

Thanks for making this video it really help me on my EP3 but when i was
working on this i opened the actuator with a knife that i had preheat at
the stove,and i just change the motor and i glue it up with crazy glue back
together and it worked for me.

Savanavanavada says:

January 4, 2014 at 1:12 am

what size have the loudspeakers…?

MADDCAPP says:

January 4, 2014 at 1:35 am

DUDE, I huffed and puffed for over an hour trying to figure out this
removal, and once you showed me to remove the window channel, it was out in
seconds, Thank You….GOD BLESS.

ttttrigg3r says:

January 4, 2014 at 1:39 am

Thanks for making this video. You’re my hero

antlogo says:

January 4, 2014 at 2:03 am

That was great! I just used this video to help me through changing the door
lock actuator on my 2004 Civic LX. The setup was pretty much exactly the
same except the white shroud covering the actuator had two screws securing
it.

soundspur says:

January 4, 2014 at 2:14 am

Great video! My problem is dire! Drivers door lock failed & remains locked!
Can’t get in or out! Difficulty compounded by having to remove the door
panel with door locked!! Not Fricking easy!! Symptom? The lock tab (next to
door lever has loosened completely: -no resistance moving between
lock/unlock!) As if a lever became detached (unless it’s all electronic!)
Just praying mine is easier. If yours was the same, then will follow your
video! Need to get damned door panel off first! Thanks!

R Joe says:

January 4, 2014 at 2:35 am

Hi, I just did the procedure but the lock still isn’t functioning with my
remote. I know for a fact that my passenger side just gone bad recently, do
u think i should replace the passenger side first in order for me to get
the driver side to work? I checked the fuse…remote, everything looks
fine…i’m at loss here thx