Limited Time: Get $10 Off Your Order
https://1aau.to/m/YT-Email-10dollars-Off
In this video, 1A Auto shows you how to install and replace a broken, damaged, or cracked upper and lower steering column cover on a 95, 96, 97, 98, 99 GMC Sierra K1500
🔧 List of tools used:
• Flat Blade Screwdriver http://1aau.to/tQA/1AXAA00013
• 21mm Socket http://1aau.to/teZ/1AXAA00043
• 8mm Socket http://1aau.to/tm5/1AXAA00017
• Side Cutters
• Snap Ring Pliers
• E5 Inverted Torx Socket
• T25 Torx Socket http://1aau.to/tdW/1AXAA00008
• Ratchet http://1aau.to/tpy/1AXAA00016
• Socket Extensions http://1aau.to/ttj/1AXAA00015
• Torque Wrench http://1aau.to/tdw/1AXAA00044
• Pick http://1aau.to/taI/1AXAA00037
For More Info visit us at http://1aau.to/h/N5/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.
Can you guys make a video on a 1994 GMC Sierra 1500 four-wheel-drive of the removal of the steering gearbox and there’s not much room to drop the Pitman arm down via the A A-frame
Do not just pull on the the tilt lever it will break
This was a very long video for a basic plastic piece removal you do not have to remove all that stuff
what is the purpose of removing the clip on the steering shaft? you did not reinstall it in the video
Can you guys make an video for a 2004 blazer shifter removed
I can't get the key cylinder to release with a pic in my 95. Followed this video to the t but it won't come out. Any suggestions?
What size screws are used in the upper and lower cover?
Can you do the ignition housing replacement
Can yall please do a video on how to replace the shifter mechanism please
What do I do if I don't have the key